Hey Tommy. What will one of these end up costing when all is said and done
Hello RC ,and Thanks for a very good question! With the exception of our 9 vane bowls, Impellers , pump kits and a few other pieces ,prices are still tenative till we get production up and running again on a more complete line .I can tell you we at this time were not offering a "production jet" but rather each drive will be custom built by us to the indvidual customers desires , specifications, engine build etc so for example a jet could have complete steering ,it could end at the bowl nozzle flange or it could have our droop ,a build could have an Aluminum Impeller , Bronze or Stainless all our jets will have our 17-4 pump shafts and were proud to say that all parts are of American manufacture *. Rest assured our pricing will be very competetive. Maybe send me your "dream build" and I'll work up a figure for you . Tom
Thanks for your patience too! Weve been working belive me The suctions have been reinforced and gussetted are in the casting loop and should be available very soon Thanks Tom
Looks good. I see some improvements we discussed. Is it possible to get one off's? I'd like to see a plug for the hold down flanges, some thing to fill the gap and make a solid area. As well as some plugs on the rib across the top, between the bearing housing near the hond hold area, Thick enouph to get a third bold for a hold down.