Performance Boats Forum banner

Longer Bulkhead Fitting

1K views 10 replies 8 participants last post by  jrork 
#1 ·
I can't figure out where to post this up and get to the best group so I'll give it a shot here.

I'm looking for an -8 bulkhead fitting that has a thread coverage area that is longer than the traditional 1" or 1 1/2".

Now that I have you all confused, let me explain better. I'm attempting to run SS lines for my water intake on the pump and have a bulkhead fitting that is long enough to extend from the outside of the pump all the way through to the inside of the boat so I can nut it on my aluminum pump support plate that's tied to my rail kit for a clean installation.

The more traditional bulkhead fittings I've seen all seem to be about an 1 1/2" too short.

Anybody have any suggestions???

Thanks so much.........john
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top