Thread:

any one know this tunnel hull

here is a true tunnel i am looking at says it is a one off . i can not find one like it . any comments good bad suppose to be a light lay up also

i can log into but can not post on scream and fly

but i have been leaning towards 1 off ..

From the side the bottom half does resemble a 20ft Eliminator Scorpion or Liberator. However they are modified tunnels with a center pod, this boat is a true tunnel and I don't recognize it. I can tell you that this could be a dangerous hull if you put too much hp behind it. Personally I'd keep the hp under 250 and be careful with the trim or you might turn this into an airplane for a short period of time. However if your only powering with carbed 200 this hull will likely be quicker than most others it's size with equal power.

ya it should be fun but i dont want to be a airplane with no wings so well be gentle that and its my first tunnel or big outboard for that matter . i got a xr4 block and will build it almost like the old one has a 28 pitch prop just have to see what we end up with.. its a light boat only wood in the thing was the transom and 2 2 food gussets neither built right i have the hull apart now and would almost like to change a couple of things but the main think i would want to do is make the boat 4-6" taller and put some sort of stringer and toe kick type support to keep it sturdy as it is a flexer may be mad to be that way but i dont like it