Performance Boats Forum banner

Ready For The Dyno

Tags
dyno ready
3K views 31 replies 6 participants last post by  Shotgun19 
#1 · (Edited)
The mill is al ready for the dyno session on Feb 21st. Should push the old cole threw the water rather well.

 
See less See more
2
#4 ·
Remember you have to push the pedal on the right down for it to go.:)hammers:D
 
#30 ·
No dyno, after talking to Shotgun and a few outher freinds, and the engine builder I cancalled the dyno and I`ll take a shot at tuning it myself.The guy I had flow the hat says nothing to it. I wasn`t intrested in the horsepower number , it is what it is. With that said I`ll stick the dyno money into a new prop and alky, since it went to the moon. Does anyone think it`ll go down any?
 
#32 ·
Its not hard, since you had that guy set your stuff up already alky is very forgiving, just set a pill in that you know is fat and make a pass and read the color around the plug, just dont let the color go all the way around the plug cause then you will have issues, have it half to three quaters of the way around and you will be fine, half is better. You will go through a couple sets of plugs before you get it right but its all in learning something new, that way you will understand what is going on with it and why. Just remember do not tune it like a gas engine, alky is opposite of gas. When you get closer to running give me a call I have a couple of suggestions as well on it so you dont have a melt down, I would hate to see that happen to you.
 
#31 ·
I have 20 gallons here for ya.:)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top