Performance Boats Forum banner

mark 4 -4bolt block, carrillo rods,13-1 J&E's

903 views 1 reply 1 participant last post by  Hass828 
#1 ·
I have a 4-bolt block that is .060 , been decked , line bore checked, O-ringed, Harblocked 1/2 way up, a set of 6.535 Carrillo Rods, & 13-1 J&E pistons. For 4' stroke. No crank.
Were this came from is a friend had an engine built for his bad azz air boat and it didnt make its power low enough in the rpm band so he had a large cid engine built and I bought this setup from him. The pistons , cylinder walls, & stuff only have a few dyno pulls.
This is block, pistons, & rods
$1200

I would prefer local pickup.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top