This motor was in my Kurtis runner bottom that I sold. It is a M&D built motor. Runs strong and starts up every time. The motor was never raced and I ran it probably 4 times (if that since Tony last went through it 2 winters ago.
Originally I was planning on throwing this motor in my Schiada. Today I was looking at how much room I have in the boat. Discovered the rudder shaft is in the way so i dont have enough room for a blower pulley.
Give me a call, Andrew (310) 930-8416 Price $12,500.00
Headers do not come with the motor.
Here are some specs on the motor
Blown Gas 518" Chevy.
Chevy Bow Tie Block.
LA Enterprises Kryptonite Crankshaft.
850 Holley Carbs
Childs and Albert Rods.
IMCO puke tank
JE Pistons. 8.5:1 Compression.
Roller Camshaft with Isky Red Zone Lifters.
Manton Pushrods. 3/8 diameter.
990 Chevrolet Iron Heads with moderate port work and
Ferrea Competition Series Valves.
Isky Tool Room Valve Springs.
Donovan Gear Drive.
Dan Olsen Oil Pan.
Littlefield Intake Manifold.
Richard Lee Intercooler.
Herbert Stud Girdles
Don Hampton 8-71 Blower. Makes 8 lbs. boost the way
it is set up right now.
Last edited by rivergames; 06-04-2010 at 01:00 PM.
Life is too short for a slow boat
Originally Posted by Tor
Balls drop, balls grow, and balls eventually get placed into a woman's purse. That's usually when the hard passes in front of Fox's stop and the busting of youth's balls start