Cleaning out the storage shed. All parts cost plus shipping from Chico CA 95973.
12 JC bowl with some normal dings on the fins but nothing that can't be smoothed out with a few minutes with a file. $50.00/offer.
36 gallon Tempo tank model 640056. Dims 68 3/4" long x 16" wide x 8 1/4" tall plus the height of the fittings. 75.00
Berk suction piece with some damage to the upper wear ring area. The wear ring appeared fine when I pulled it out but the shoulder that the wear ring buts up against is concave and the upper area where it meets up with the aft side of the hand hole area is chewed away. Shaft is fine with some wear areas where it seated in the rear bowl bearings. $50.00 or I"ll pull the shaft and ship that!
Berk transom rings, have two, 25.00 each
Berk clean out cover, 20.00
4" stainless exhaust Tee's, 75.00
4" stainless exhaust elbows, 35.00 these are not true 90 degree but a bit over
3 bronze fins, 2 are matching, one not (slightly bent), off a tournament boat I believe, 50.00/pair, 30.00 single
Carb wedges, one on the left appears to be hard plastic and has as chip in the corner as seen, 20.00 each
3 Morse MV3 or similar single handle controls. Top one is brand new with neutral safety switch 125.00, middle one is used with gutted neutral switch 75.00 and bottom one is used with no neutral safety switch provision 45.00
Barr cast iron center riser SBC manifolds less risers, 100.00 pair
1 1/8" strut off a Ski Brendella, 75.00