Performance Boats Forum banner

540

  1. Parts for Sale
    Completely Brand New Blown Dart 540 with a 10-71 Blower Shop Blower. Built with the best of everything. Total build cost: $28,601.59 / Asking $26,500.00 1150 HP Initial start and break in time only Ready to drop into your boat and go Will meet and load engine for shipping Please ask any...
  2. Parts for Sale
    540 Cubic Inch Complete Blower Engine - $15,000 540 Cubic Inch Blower Engine built by Pete Fleming. Dart Tall Deck Block, Calis Crank, Oliver Rods, Arias Pistons, Billet Fabrication Oil Pan, ATI Damper, Polished Pro Aluminum Heads, Jesel Shafted Rockers, ARP Studs, Crane Hydraulic Roller Cam...
  3. Parts for Sale
    Fresh Blown 540, standard deck Bow Tie gen 4 block, Lunati Pro series 4.25" crank, ATI Super Dampner, Lunati Pro billet 6.385 rods, JE dished Blower pistons, ARP main and head studs, Cometic head gaskets, BBC alum Bow Tie 861 W port heads fully polished on outside set up with Jessel shaft...
  4. Parts for Sale
    Used (very little) BBC Dart BIG M engine block. This is Dart P/N # 31263444. This is a cast iron block with Steel BILLET main caps which are 4 bolt splayed for extra integrity and strength. Standard cam location and 2 piece rear main seal. Standard 9.80" deck height and this block is finished...
  5. GN7 On the Dyno
    Hello, It seems that I have to turn to the boat guys again for some motor info. I'm close to finishing the build, and am concerned that I may not make the power I want. The combo is: 540 short block (8.5), total seal rings, ported RHS 320 heads 390 intake, 298 exaust @.800 lift, Super Chargers...
  6. GN7 On the Dyno
    Hello, I am a car guy and I dont know anything about boats but I have a question I hope you guys can help me out with. I picked up a 502ci Big Block 4 bolt main with rectangle port heads casting # 14097088. The guy who built this engine builds racing engines for both drag boats and offshore...
  7. Parts for Sale
    540 short block for sale. This is a World Products Merlin II block. These can go 4.625" bore. Block is currently 4.530" bore. Will need bored to 4.560". The block includes ARP main studs. Specs: http://www.worldcastings.com/product...ron-block.html This engine includes a Crower 4340 forged...
Top