Performance Boats Forum banner

bottle

  1. Parts for Sale
    Bottle is full and comes with new regulator and lightweight quick change mounting bracket. $250 in shreveport, la. 318-687-9088 or 318-470-1482
  2. Parts for Sale
    $75 a piece takes them. The come with the 1/2 inner diameter dip tube, a pressure gauge and blowoff fitting. Located in San Diego. Shipping not included
  3. V-Drives
    Where is the SoCal go to place (near Costa Mesa) to get this re-filled? I assume it's CO2, never had one before. Also might want to just buy another complete bottle to keep in the truck in case one goes empty. Am I over thinking this? Jocko
  4. V-Drives
    I'd like to mount my carbon dioxide bottle flat horizontal. Is that a bad idea? I've only seen them mounted vertical.
  5. Parts for Sale
    looking for a on top of the stringer mount for nos bottle thanx bev
  6. Parts for Sale
    Hard Anodized 2.5 lb co2 bottle bracket $50 sold 10" steering wheel $50 sold 1350 drive shaft chromoly center section 14.75 inches u joint center to center $100 Moroso PN# 23766 Remote Oil Filter head with -12 fittings, bracket for mounting on back of cylinder head and 2 spare filters $75 sold...
  7. Parts for Sale
    Selling a 5 lbs. air bottle. Good condition Asking for a trade for a 2 1/2 lbs. air bottle or sell the 5 lbs. bottle for $100.00 plus shipping We will be at the next race at Wild Horse Pass March 14th and 15th. Will bring to save for shipping ***Small blue bottle not for sale-in picture to...
  8. Parts for Sale
    I NEED A OLD NITROUS BOTTLE FOR DISPLAY ONLY I GOT THE BRACKETS CAN B OUT DATED NO WORKY ..... CHEAP............. SOMEBODY HAS 1 LAYING AROUND.. THEY R NOT OR CANT EVEN USE...........:duh::)hand
  9. GN7 On the Dyno
    Is it necessary to run a bottle heater for a nitrous setup on a boat. I am only using a plate system 150hp. My only previous experience with Nitrous is on LS platforms and always dry spraying through the MAF and I heated the crap out of the bottle more psi meant more hp. I do not have any...
  10. Jet Boats
    Is anyone getting their bottles filled anywhere around here? It's not Parr or Smileys anymore. Guess I'm going back to blowers....
  11. V-Drives
    Does the C02 bottle have to be in the upright position or can it lay flat. Thanks
  12. Parts for Sale
    AeroSpace Nitrous Bottle Bracket. Single nitrous bottle mount. $175 Contact Jeff at 505-228-8221
  13. Jet Boats
    So will it be alright if i place my bottle this direction? Will it affect my nitrous shot under acceleration? Thanks Trevor.
  14. Parts for Sale
    New rebuild and gear. $150obo or trade nice bottle and will thro in line and extra brackets for skinny bottle. Polished bottle has brackets. $150obo or trade.
  15. Parts for Sale
    With cheater solenoids and purge solenoid all wired into one weather pack connector, with Mallory fuel pressure regulator 400$ firm, the bracket for the tanks alone cost that, also the bottles both have high flow valves Eric 626-991-2129 text me for pictures Located in Covina ca
  16. Jet Boats
    Fill it everyday, every weekend? What size bottle is everyone using?
  17. WFL Crew
    today i made some bottle brackets but now that i took out my sub floor i dont know were to mount it.I was thinking about going from stringer to stringer with some angle and mounting the brackets to them.show some pics how you guys have yousr mounted. i really dont want to go through the hull. thanks
  18. Other Stuff for Sale
    charged one system out of it a few weeks ago......175 local pick up
  19. Parts for Sale
    Has quick relese pins. missing fancy bolt on small bracket. $70 shipped
  20. Parts for Sale
    Bottle has been filled 3x's. Brand new. Blue, with high flow valve. $200.00 ****pick up only****
Top