Performance Boats Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-15 of 25 Results
  1. GN7 On the Dyno
    Engine setup: 454 ~10:1 72 chevelle round port heads Lunati Voodoo flat tappet hydraulic stage 5 Lunati stage 5 valvespring kit Harland Sharpe 1.7 roller rockers Proform gear drive set Edelbrock TRX2 tunnel ram Dual Holley 4160 w/ sec plate kits (68 pri, 70 sec) MSD ProBillet distributor(w/...
  2. Off the Water
    Didnt know where to post this since its not a boating event but worthy all the same; HOMES FOR OUR TROOPS is breaking ground on a new home for one of our many hero's This young veteran has given his all and has sacrificed for us and now it is time to pay it back. There will be a ground...
  3. Jet Boats
    I need some advice breaking in new cam and lifters in fresh rebuilt short block. Paper work that came with the motor says to add a bottle of zinc to the oil and change the oil after the first 2 hours. Add the second bottle of zinc after changing the oil and change oil again after 20hrs. Do I...
  4. GN7 On the Dyno
    We had a blown injected 522, but we put the induction on another motor and installed a tunnel ram with dual 750's for the time being. We also had the cam reground and installed a mechanical fuel pump. We are using the same solid roller lifters so I'm assuming there is no break in required for...
  5. Jet Boats
    Whats the best bet when you have to fire up a new motor for the first time and break in a new camshaft as well? I have never ran the boat on the trailer, except for a few seconds at a time to check things. It has a water hose hookup that comes off the back of the pump, and then goes to a "T"...
  6. PB Open Water
    Perfect ass this cop is...Daytime in No Time | Yahoo! TV
  7. PB Open Water
    What'd you think of the fifth-season capper? Now to wait until next summer for the last eight episodes.... ​
  8. GN7 On the Dyno
    ok guy's,I'm trying to help out a buddy thats not on the forums. he's trying to build his own sbc for his jet boat. He's not stupid ,but he's not an engine builder. he's broken 4 NEW scat (arp) rod bolts. he claims torque spec is 45 pounds,he's breaking them @ 40.says he's using there...
  9. PB Open Water
    I just finished watching the fourth (and most recent) season of this show, and I have to say, I'm pretty damned impressed. Excellent writing, plotting, acting, directing...what a wild ride. At times it reminded me of "The Shield," with its antiheroes, drug plotlines and seriously badass...
  10. PB Open Water
    how long before i can get on it with a freshly built 468 bbc with a flat tapped cam?
  11. PB Open Water
    A young Tom Brown takes intimacy to the next level :gas:
  12. Jet Boats
    How do you guys go about breaking in a new motor? I know with a car the basic rule is 500 miles of gentle driving, etc... Not sure with a boat motor. The cam break in I understand well enough, but do I need to putt around the lake for a while or what? Also, is 10w-30 oil heavy enough? I feel...
  13. PB Open Water
    Soooo I have this vacation property for sale up by flaming george. Somehow between my realtor,my brother, and the neighbor up key to the garage is lost. Can anyone tell my how to drill it out, or???
  14. PB Open Water
    Did anyone else notice all of the snowbirds leaving town yesterday and all the boats coming into town? yipeeee!!! :)
1-15 of 25 Results