Search Results for ‘bushing’

FTN Nozzle Bushing. $39. 3.125" brand new. Free shipping. 918 two six nine 8084

Here is a SBC .936" that was in a Desert Offroad Truck application. The wheel still rolls after 200 miles of the lobe being in failure.

When I looked into a kit like this last year, the price was outrageous. Just stumbled across this kit offered by Straub Tech. at a price I can swallow. LS bushing trunnion kits - Straub Technologies From memory, the other kit I was drooling over used Bronze bushings with "self lubricating"...

Who do you guys use to replace strut bushing in Parker area. Thanks Rich

Does anyone know where to buy new 1 1/8 prop shaft strut bushings..I want the black hard plastic ones, I used to have Braaksma make me a couple sets but thats gone, God speed Ron, we miss you..thanks

Looking for advise. The aqua-lube bushing that is in my prop support strut keeps coming dis-lodged and slides down the shaft when I am running. I recently replaced the bushing with a new piece and snugged it into to support. It was not super-tight, but it was not falling-out loose either...

I have a Mach 1 v drive and I put all new bushings in strut, wip strut and stuffer bushing. I have a water cooled ca sale that dumps into the stuffer. Every time I put in water and run out from marina it spins the stuffer bushing with the shaft and rips my fittings off. Once it does it then I...

Hey Guys, Anyone care to share their tricks for removing old strut bushings. Need to replace at least the prop end and would like to change out both ends while I have the shaft out. One way is to use a hacksaw blade and carefully cut thought the bushing (I assume in two places, remove the...

Finally in:

Got some vibration, little clearance, whats the preferred material-source for a 1" propshaft bushing?

Hope this is the right place to post this...... I "tried" to pull the shaft. The plastic one that was in it was melted. I cut the part that was sticking out of the front of the strut (pic on the work bench) and got the shaft to come back about a foot where it is semi stuck until the kid gets...

I'm trying to replace the bowl bushings in a berk jg during the rebuild. One of the bushing falls right through the bowl (zero tension to hold it in place) What is the fix for this? Thanks

I just put in a new strut bushing and Im about to slide the prop shaft back in and I dont remember last time I put the prop shaft in having it be this tight. Any tips or tricks?

What are you guys using? Delrin is easy to find. Turcite or whatever is tougher to find. I have a lathe and a tape measure, so I'd prefer to make my own. Sources for turcite?? or whatever. Wags

sweetee got me a new toy for b-day.

Have two MSD 8464 bushing and spring sets for MSD distributors. $10.00 each plus the ride.