Performance Boats Forum banner
bushings
1-8 of 8 Results
  1. V-Drives
    Who has some new bushings for a 7/8" cav rod? Mine are a little rough inside and looking to buy some new ones. Any help would be great. Thanks
  2. V-Drives
    So I'm doing a pre-season freshen up on the Bezer and strut bushings were on the list. Pulled the old ones out, knocked in some new ones in and the shaft fit is pretty tight. Normally I like the bushings snug but I can push the prop shaft in with my foot. With these I had to tap it in with a...
  3. Jet Boats
    Freshening up my bowl bushings after 4yrs and ive been using gear lube since i installed them and have used gear lube on all the pumps ive done for myself. im thinking about switch to red and tacky for the bowl as well. does it wear more? I was told to water lube them but ive never tried it...
  4. Jet Boats
    I was trying to put the kids boat together but the bushings fall right thru the bowl, any thoughts? Split bowl.
  5. Jet Boats
    So i rebuilt my pump got a little ahead of myself and popped the tail shaft bushings out before I realized i needed to put them back in the same spot they came from. Little help would be appreciated.
  6. Jet Boats
    I posted something similiar to this but i figured the jet guys would look in here more frequently than the norcal section. Im located in sacramento and all the machine shops are closed. Im looking to get the bushings into the bowl today/tomorrow so i can finish the jet install and hopefully...
  7. V-Drives
    I`m kind of tired of running the fiber type bushing.so my question is I`ve heard about red brass and turlock or something like that.If I heard right where do i get this stuff at?also do i get it in raw stock form where i need to machine it or does someone make it already. I always cut the fiber...
  8. Jet Boats
    Does anyone know where I can get a couple bushings that go in the steering nozzle without paying Rex Marine $15.00 just for shipping plus the cost of the bushings? Roger
1-8 of 8 Results
Top