Performance Boats Forum banner
calgo
1-20 of 49 Results
  1. Jet Boats
    The calgo steering is the last thing to do before it hits the water, I need some pointers on the installation any advice would help out alot for a smooth install,thanks
  2. Parts for Sale
    i have 2 struts for sale. one is a stelings i think its 8 degree. theres a stamp on the base. the other has 007, maybe 7 degree? both are for 1' shaft. $200 each + the ride. also calgo steering 5" shaft. with genwood rudder arm, $100 obo + ride. 1" brass rudder box $15. call bill at 718 759...
  3. Parts for Sale
    Looking for a standard flat tiller arm for a berkley pump,,,,,,,,
  4. V-Drives
    My buddy has a 76 Sanger drag shovel with outboard calgo steering. It was recently rebuilt. It turns easy when the boat is just sitting but at any speed it gets hard as hell to turn the wheel. Is that common for that type of steering, in that type of boat?
  5. Parts for Sale
    Anyone has a tiller arm out there? I'm running a droop so an offset one is fine or a standard flat one with a long shaft or even no shaft let me know,Thanks
  6. Parts for Sale
    Looking for a complete Calgo system that someone maybe changed there mind and is going a different route.
  7. Jet Boats
    Anybody have a picture of the calgo tiller arm used with a place diverter? I have a tiller arm that is gull shaped and am concerned it won't work with a place diverter type control. I assume there is a clearance issue between the width of the t. arm and the hyd. ram actuator bracket. thx
  8. Parts for Sale
    I parted out a late 70's 22 foot Vdrive and have these parts available for sale. Part description and prices as follows: Ace Champion 12Deg VDrive gear box 1:1.04 - $375 Borg Warner Velvet Drive AS11-72C with Nicson BBC bell housing, Nicson Stringer mounts and oil cooler - $700 Complete Calgo...
  9. Jet Boats
    How big a pain in the ass is it to convert over to Calgo ? And what will it cost for hardware ?
  10. Parts for Sale
    I'm looking for a Calgo Steering System with post. Used or New!!!!!
  11. V-Drives
    Can someone post a pic of how Calgo steering with sheath wraps around the rudder Quadrant.:hmmm:I am starting from scratch. Replaced new cable steering is nice and smooth in hub unit.
  12. Jet Boats
    I must be missing something here, the steering was recently rebuilt by Norm, but when I tighten it up the steering gets very hard and there is a dragging sound coming from where the cable goes through the hull. Am I missing a sheath or something?
  13. Parts for Sale
    Nozzle has yellow insert that is a bit worn. Bottom has been welded and smoothed. $140 located in Valencia CA PM me here or email [email protected]
  14. Jet Boats
    is he the one that mathankskes it or has it if so is there a # for him
  15. Parts for Sale
    Have new style manual place diverter that is 2 years old, need steering arm PM me here or email [email protected] Thanks
  16. Jet Boats
    I bought a boat with Calgo steering and was excited about it until I realized it has 1 1/2" of slop :)st I understand GSM in Sun Valley is the place at 818-504-9181. Called twice and left a message with no response. Answering machine says "we're not in the shop right now leave a message and...
  17. Parts for Sale
    Used calgo steering out of a jet 4- sale SOLD $200 shipped in US OBO
  18. Parts for Sale
    Calgo Housing out of 19 TPR Left Steer 2 Seater $25 or pick up here for free 951-318-1998
  19. V-Drives
    Anyone on the boards have a contact to calgo Steering GSM? I need the right side cable replaced that has alot of fraying where it wraps around tiller. THANKS. I do have new cable. Will post pics tomorrow.
  20. Parts for Sale
    I'm lookin for the bracket that bolts to the bowl bolts for the calgo cables
1-20 of 49 Results
Top