We guarantee it will out-perform any cast aluminum exhaust system!
That is a promise no one else dares to make!
The innovative Thunder & Lightning bolt-on cast aluminum exhaust header boosts your engine's performance 35-100HP! This unique foundry-tough cast tube style header incorporates four...
BBC cast Iron 990 heads these are the Older style, Good ones without the pressed in valve seats, with 11/32 valve stems just tanked and magna fluxed no cracks and they come with all the valves! Located in Havasu We have four sets of these asking 485.00 Obo + Shipping, the casting numbers are...
Cast Aluminum Mr. Gasket Twin Carb Scoop
Adjustable spacing. Hole Diameter just over 5".
Polish is 8/10. Looks good but not perfect. Can ship to lower 48
text 661-644-7560 or send PM on here.
asking $100 obo
I have these two cast Sanger SB101 seat brackets. I don't need them so thought maybe a Sanger boat enthusiast might ...Free to first Sanger person who says they want them ! No flippers or metal scrappers ! PM me shipping info and just cover shipping costs.
Got a PCM 454 330hp with some rusty iron factory manifold/risers. I also have some old alum logs with snails available. Is there any performance difference between these two options? I realize that neither are great for high performance apps but was just wondering if going to the logs would have...
Adjustable width B/B Chevy Motor plates/mounts for Jet boat, Cast polished aluminum (one mounting foot is chipped, hard to see will not effect mounting) see photos, uses stock position starter Currently set up for 26" width can be adjusted in or out 1"+ or so...
$120, OBO + ride shoot PM
:bangmyhead: Building up an old school 61 Fairlane and I'm looking for M/T or Offenhauser finned aluminum valve covers. I'll take them even if they need polishing. Shoot me a picture and your price, Thanks!
DEFECTIVE SAND CAST ALUMINUM IMPELLERS!... Not American Turbine ours are investment cast aluminum.
I got a call yesterday asking me about what is the minimum thickness at the wear ring skirt. I told him that for a sand cast impeller it should be at least .150" because the sand casting technique...
4.625 X 4.375 pump gas. May do AFR377 or CFE. 6000RPM. Trying to get 2.35 valve in this thing.
What cast TR is out there? Or just get single 4bbl. Have the Snippers/II/Jr been dialed in yet? Maybe 780-810HP
and all the TQ for the most amount of time. 25 Daytona cruiser