Performance Boats Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 29 Results
  1. Jim Wilkes
    I took my V-drive out for the first time and about 1-2 oz Gear oil came out of the top vent on a Ace Champion. The oil level was just a tad above the center of site glass, would that cause the oil to push out of vent? I checked the oil and level after the test run and There is no water in the...
  2. Parts for Sale
    Hello, I'm looking for 15 to 18 gears for an Aces Champion. I have 29's now and would ideally like to trade with someone who wants more gear. Box for box. I replaced my turbo motor with a NA, and 29% is too much. Call if you have anything. 559-392-6444 Thanks, Jack ACESPACK
  3. V-Drives
    Gonna be repowering my 73 spectra 20 and was wondering how much horsepower that drive can handle? any thoughts?
  4. V-Drives
    I was going through some stuff and found a set of eight Champion RF9YC plugs. I bought a few sets years ago for my flatbottom, it had a 427 FE in it. I sold the boat a few years ago, so this set is a leftover. These would be nice if you have a vintage flat or rod with an FE in it. They are NOS...
  5. V-Drives
    How do you tell when this thing is filled? I can see the sight glass in the front and it is completely covered in oil. I can't see the top of the oil until I raise the tongue of the boat approx 3ft in the air. That cant be correct, can it. The box is in a 74 spectra20. The PO said he had it...
  6. V-Drives
    Hello all, I am new to the forum and I am doing research on the old National Champion SS-92. If anyone has any information at all could you please lend a hand. Thank you in advance, great forum.
  7. Parts for Sale
    Weeding out excess from my shop........ 1950's vintage Champion model 1000 spark plug tester, (not a cleaner). Comes with 50's patina, adapters for 14MM & 10MM plugs. "WORKS GREAT" $100 plus shipping..............
  8. V-Drives
    Picking up some 19's today to replace my 29's. Looking for directions, or any advice on how to do it. I must get it done this weekend, so any help would be appreciated. If there are seals, gaskets or whatever I will need to get on order, please advise. Thanks in advance for the help. Jack...
  9. Parts for Sale
    12*Champion MK II, W/9% Casale gears, 1/2" center plate,case is machined for large bearings and bearing caps, casale in/out W/1"shaft $750 plus shipping from San Diego
  10. Parts for Sale
    I have a completely rebuilt Champion V-Drive with 29 gears. We thoughts these would be a bit much for my 21.5 ft Hallet; but we thought it might work. Well it doesn't; we really need 18's maybe 22's at the most. I may even consider 15's. My box is rebuilt and has less than four hours on it...
  11. Jim Wilkes
    I'm resurrecting a '72 Eliminator "vee bottom" with a Champion v-drive. I've owned a number of Casales but this is my first Champion. I've just replaced leaky oil seals and I don't know where the oil level should be when I refill it. The plug ahead of the output shaft looks a little like a...
  12. Boats for Sale
    Peter Guy, a previous owner of this beautiful 1978 Rayson Craft, converted the boat to include a reinforced cockpit. Bart Cromwell then purchased the boat with no engine, built a 496 and raced it for five years in the GN Nostalgia class (331 GN), where he won virtually every race he...
  13. V-Drives
    SE Summer Nationals Champion SE-200 Marc Halversun in his Jones Starfire Gettinghis weight and then off to Tech to get motor inspected and yes he passed inspection.
  14. Boats for Sale
    Peter Guy, a previous owner of this beautiful 1978 Rayson Craft, converted the boat to include a reinforced cockpit. Bart Cromwell then purchased the boat with no engine, built a 496 and raced it for five years in the GN Nostalgia class (331 GN), where he won virtually every race he participated...
  15. V-Drives
    I have a 24' Spectra XS v-drive with this combo in it and was wandering how much HP I could put in it with our having to upgrade these two items? I was thinking in the 700-800 HP range, would that be a safe number with this combo? Thanks for your input.
  16. V-Drives
    Charlie Hamill won the 1st Worlds Championship for SE at Waterford Michigan this weekend. Here's a picture of Charlie and 2nd place Pete Hackett. I'm sure Charlie can fill you in on the rest of the details.
  17. V-Drives
    Im looking for the breakdown diagram of the champion v-drive. Ive seen it on here before but can't find it on the search. Anybody know where one is at? Thanks
  18. Parts for Sale
    new old stock $1.00 each AG 203, AG403, AG603, AG903, N57R, N54R,
1-18 of 29 Results
Top