Search Results for ‘chrysler’

I am looking at swapping out the BBF for a chrysler 440. Right now I am on the hunt for basically everything for the swap mounts,pto, ect

asking 75.00 obo local pickup? like new condition.

426 Hemi chrysler New Nicson exhaust logs (SOLD) New old stock polished nicson aluminum exhaust logs, fits 426 Chrysler hemi, never used. $500.00 pair, Jim 1818-890-1867 ( SOLD )

New user, hope it's ok to post the link to my listing on ebay, tons of pics and info. Pm with any questions and thanks for the ad http://r.ebay.com/cytqhs

I know its a long shot but I got an oldie with a 1967 Poly 318 in it. I need a 4BBL. Manifold for it. Iron or Aluminum I don't care. No other small block Mopar will fit it. It has to be a Poly motor manifold. Not having much luck. I know they made them but haven't found one.

I have 2 of the flywheel cover mounts and 1 of the front mount. Glenwood shows Chrysler 361, 383, 413,426 and 440. $100.00 each + ride. Or pick them up. 95604 now and will be headed Long beach tomorrow, I can take them with me.

Anybody have one?

Sold! Sold! From this. To This.

Looking for a good used set of aluminum water logs for a 440 big block Chrysler, :))THumbsUp Thx John

Chrysler Marine 331 C. U. Carb to pan trans to front gear drive Exhaust manifolds ignition wire starting All stock Chrysler Marine Engine Fox Lake barn find Truitt Beal 703-345-6576 Broadview, Illinois $4000.00

Rewarder chrome zoomies for a 392 Chrysler hemi. Pipes are 2.5" OD and come with 8 baffles. Set up for water lines. Chrome is in excellent condition. Pipes have a 1.25" wide support strap on both sides. $500 + shipping. (949)248-0083 or [email protected]

SOLD-1969 Chrysler 383cid b-block motor $2500.00 OBO 383 chrysler completely rebuilt to stock specifications. motor Block completely restored and bored. New pistons, rings, crank bearings, rod bearings, and camshaft bearings. New starter, distributor, carburetor, coil, valve covers, and fuel...

did anybody ever make any ski tows that bolt to the motor on a 440 like Glenwood or Harmon marine ? or dose anybody have one hidden away in there garage that they would part with thanks.

Up for sale are 5 sets Top Halves Only Rod Bearings for the 426 Chrysler Hemi from Childs & Albert p/n R4264B std.. these are typically used in the BAE Hemi...$150 for all 5 sets Thanks for looking

BB Chrysler Sale Pending Located in Hugo,Ok

It's a 1971 12.9 and it's going on my aluminum boat! Herb was cleaning out his barn...thanks again Herb and merry Christmas everyone!

(Sold) Chrysler Hemi Water Manifolds I have a set of "nice" Chrysler (354/392) Nicson water manifolds for sale - - $450.00 + shipping. Call (626) 375-4286 (cell) - ask for Lynn - located in SoCal. Thank You for your interest - SOLD - 12/15/2014 !!

Chrysler Edelbrock rear engine mount, good shape no cracks or repairs. $150.00 + shipping

looking for a bit of basic info before i hit the water. wanna try a few props but need my selection to be close so i dont have to make a bunch of trips to the boat store. whats the ideal WOT RPM for this engine? what is the final drive ratio for this engine? that should get me close to what...

For