Performance Boats Forum banner

expect

  1. V-Drives
    Need to go through the engine, so it has to come out. Its currently behind a velvet drive, what should I expect while pulling it? No torque converter, drive flange should be mounted to the flywheel? Is it easiest to just unbolt the engine from the bell housing, and leave the bell housing and...
  2. GN7 On the Dyno
    There are a few parts I may need modified and would like to get an idea of what it should cost... #1 I'm considering using this crank driven water pump. But, by looking at the picture, it looks like the drive flange will have to be turned down to fit inside the hub of the damper that I have...
  3. Jet Boats
    I'm toying with the idea of a 77 18' V bottom Southwind as my next "quick" project. I am trying to figure out what it takes to make one run in the mid 70's for power and setup. It has a basicly stock 454 with headers, berkley 12jc pump, berkey jetovater and full length stringers (beefed up...
  4. PB Open Water
    Celebration at noon in Arcadia from the boards? Memorial services are going to be held on Saturday June 27th at 12:00 pm at Arcadia Elks Lodge 27 W. Huntington Dr. Arcadia, CA 91006. The link for the location is http://www.arcadiaelks.org Dress is casual and a reception will follow the...
  5. GN7 On the Dyno
    I'm in the process of putting my motor back together for my TX-19.I had problems last year so here's the build for this year,not to wild.454 0.60 over ,stock crank ,ARP main bolts,stock rods with ARP bolts,10.5 TRW forgded pistons,Comp solid mech. cam 629 lift, 262-262 duration on a 106 intake...
  6. PB Open Water
    The $ question is...will it continue?
  7. GN7 On the Dyno
    I dunno ... I think I've lost it. It may be time to part with the old suburban and try to build a real motor. Just trying to get a ballpark. I'm hoping to use my brodix bb2plus heads and my vic jr carb. Seems like last time I priced a rotating assy it was 2200.00 (eagle). I hoping for 700 plus...
  8. PB Open Water
    Fill up today, Gas is going up again:)coffee:)coffee:)coffee
  9. Parts for Sale
    So honestly speaking what would you expect to pay for this through top end engine builders with a year warranty? Im making the build public on the website and I know what Schmidt, Teague, Rherr & Morrisson etc charge...I want to see what the market thinks is fair... Good thing with me running...
Top