Performance Boats Forum banner

filters

  1. New cams lifters push rods filters etc.

    Parts for Sale
    Everything in this paragraph brand new free shipping 7809-16 push rods 5/16 7.226 $30 424 bronze gear Chrysler .484 shaft $50 .2100 SBC Magnum timing set $22 7372-16 Magnum push rods 5/16 7.800 $90 853-16 SBC hydraulic rollers $400 854-16 BBC hydraulic rollers $400 813-16 solid flat tappet Chevy...
  2. Fuel pumps, rails, filters, t-tank plates

    Parts for Sale
    All prices plus shipping from 60031. Prefer to ship usps flat rate when possible. Two Holley Blue fuel pumps. Touched both on car battery, spun right up. One of the right sounded like new, one on the left sounded good but just not as strong as one on the right. Left pump $50. Right pump...
  3. Fuel Filters & electric pumps

    Jet Boats
    This question is mostly for those with dual tanks, electric pumps and motor that runs on pump gas. What are you using for a filter? Before or after the pump? What micron? I have a Holley blue and 850 double pumper. My block is a Gen VI so no option for a mechanical pump. My original though...
  4. OIL FILTERS Here we go again.

    GN7 On the Dyno
    Doing a little reaserch today for industrial sized water/gycol filters, and one of the sites I hit was Luber-finer. One of the oldest oil filter manufactures in the country, if not the world. And what do I see in the far upper right corner of the page, where you enter site searchs? FRAM. WTF...
  5. [SOLD] system 1 oil filters

    Parts for Sale
    new system 1 oil filters long one is $100. short one is $80. plus the ride
  6. Siera Fuel Filters 18-7845

    Jet Boats
    Anybody know what kind of HP these things support? I found a site claiming they flow 90 GPH but my pump flows 150
  7. Fuel Filters?

    GN7 On the Dyno
    I have a canister filter/ separator before my Holley blue pump. What micron size/ Material/ PSI should I be looking for in an in-line filter for after the pump? (8 AN line between the Pump and reg.)
  8. lean condition with air filters on???

    GN7 On the Dyno
    Have my motor on the dyno and it was running rich. We put the air filters on and it went way lean 15:1 and climbing from a steady 11:1 before the filters/spark arrestors. blower motor 850 demon blower carbs. basicly we cut the tops off the spark arresters and now it about a two inch volocity...
  9. oberg oil filters any opinions or thoughts?

    V-Drives
    Has anyone used oberg oil filters and if so what did you think of them? I have 2 new ones in the shop and was thinking about trying them out.
  10. [For Sale] Pool Equipment... Filters & Pumps

    Other Stuff for Sale
    I am a pool guy and have some extra parts/equipment. I am tired of storing it so please help me get rid of it. MAKE OFFER!! -Hayward DE Filter Lid 60 SQFT -Hayward Cartridge Filter -2 Wisperflow Pumps. They both needs new motors but i believe one still runs, but just a little noisy. DE Filter...
  11. [SOLD] 8 & 10 Fuel Filters

    Parts for Sale
    Billet , w/ mounts, new $ 40 ea
  12. [SOLD] BG Fuel Pump, Reg, Edelbrock Filters

    Parts for Sale
    $ 250 plus shipping, or we'll bring it to Long Beach !
  13. K&N Filters for Tahoe/Silverado/Suburbans

    Parts for Sale
    I have two K&N filters. One came out of a 2008 Tahoe and the other out of a 2008 Silverado. They are exactly the same. They run about $60 bucks new if i remember correctly. These are in good condition, just cleaned and oiled. Asking $30 each.
  14. Hepa Filters

    PB Open Water
    Our granddaughter has asthma, and the doctor told us to get a hepa filter set up for the house, anyone ever use one? is one brand better than another?
  15. K&n air filters

    Parts for Sale
    Universal air filter. Never been used, still sealed from factory. OD of flange is 5 1/8 inches by 3 1/4 inches and filter is 6 1/4 inches tall Make reasonable offer / you pay shipping The info below is from K&N's web site. 62-1490 Product Specifications Product Style: Rubber Base Crankcase...
  16. Wix Racing Filters

    GN7 On the Dyno
    The local shop that i normally get WIX filters from just started carrying the WIX racing filter. Same PN Number just with a R at the end. The shop says it's a better/full flowing filter, i'm curious what the difference is. Price is almost double over the normal WIX i get. Anybody know what...
  17. K&N Air Filters & Breathers

    Parts for Sale
    Single 4150. Element is 2.5" x9". $20.00 each. Buyer pays shipping.
  18. k&n air filters

    PB Open Water
    Does anybody have any information on a k&n air filter on a duramax diesel.want to install one but was wondering if anybody thinks they are worth it.thanx
  19. K&N filters

    Parts for Sale
    I have a K & N air filter with a carbon fiber lid. On the K&N web site the lid is priced at $ 254.83 There is a 14'' X 4'' element and chrome bottom. The element on the K&N web site is $77.62 This is a total of $332.45 I am asking $225 plus shipping for the whole set up. In the 2nd picture...
  20. Oil Filters

    Jet Boats
    What is the biggest oil filter that can be installed on the stock oil filter housing on a 455 olds? I want one larger than the small stock one, will hold close to a quart of oil, and can be bought at a local auto parts store. TAPPED
Top