Check this stuff out. Only 281cid and over2500hp, 52psi of boost, on gasoline, 9600rpms, OEM block, OEM heads, OEM rockers, ect.
John Mihovetz Runs 6.05 With 4.6L Mod Motor Mustang In Pomona - StangTV.com
bet he could go real fast if he had a set of big aftermarket heads on there so he could...
I am looking at retirement in the next 4 to 6 years and would like to leave California. I am just fed up with all the crap going on in this state as I am sure many of you are as well. I have small kids who will be teen and pre-teen ages when I retire so my focus would be on a good location to...
After alot of sleepless nights I've decided to pay a professional to fill all the holes in my Rogers. A good friend of mine lives in Havasu and is a customer of Scott Kornowski. So tomorrow morning I'm off to Havasu with the boat to get the all the holes filled. I had thru transom exhaust and...
well Just back from giving camp oil bath stain job .
Now onto getting ready to go to fote FEAST OF THE EAST
heading to graphics shop new # s on boat see some of you guys in a few days
hope weather is nice . here is a shot of the new look used 15/40/new hyd fluid mix
Got the manifold on today, couple of problems, your linkage plate hits my valve covers, i'm going to have to fabricate somthin up. Had to change out a couple fittings since you use -10 and i use -8. Gettin close!
Also did alittle cleaning/polishin on your manifold :)
It sure is nice to see you guys gettin along for the holiday season!!! Now, i don't know any of you personally so don't get offended..but i think the video includes sleeper,miked, shoe, cs19 , 509
you may have to ex out and click on it again if it won't load...