Performance Boats Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-19 of 20 Results
  1. Parts for Sale
    Big Gun Exhaust and Pipes, Less than 40 hrs in fresh water, like new, no dings, with gaskets , bolts, 4 inch pipes.The original GIL BIG GUN for big cubic inch motors.BBC. $2,000. Plus shipping. 707-900-1230
  2. Parts for Sale
    Used Gil Marine Exhaust and SS Risers. Located in Southern California.. $1100 or best offer Travis 951-368-4208 [email protected]
  3. Parts for Sale
    Very Nice pair of Gil-Mercruiser exhaust risers in great shape- $200 Aluminum hamburger dry sump pan for i dont know what engine?- $100 very nice gauge cluster for under dash mount- has sensor type fuel pressure-oil temp-and water pressure-auto meter gauges- comes with long stainless number 4...
  4. Parts for Sale
    Starter, Mini Alt. etc. Reveres rotation HP Delco PG20M Powder coated starter never used $200.00. Used powder coated Mini Alt. $100.00. New Mercury steering pump $100.00. Everything is in Parker Az. or can bring back to SoCal if needed. Shipping is extra. Thank You, Bobby (805) 432-5738
  5. Parts for Sale
    Looking for 2 sets of gil dry tails for bravo, have manifolds need dry to tip tails
  6. Parts for Sale
    Gil long tube chrome headers for a SBC. The headers have baffles installed. Water lines are included with the sale. There is some blueing on the chrome that will likely clean up with some polish. I received these with a boat I just purchased so I have not run them personally. Buyer will pay...
  7. Parts for Sale
    I bought these on ebay for a boat i was going to build but never used them and bought a completed boat. Must go best offer. They were tested to 30lbs held presurer 48hrs. Guaranteed. Call mike 702 610-9130
  8. Parts for Sale
    1 pair Aluminum gil manifolds and sound select tailpipes for BBC, came off HP500. Freshwater only, great condition. 1 tailpipe stud missing and no nuts, all water lines included. $1200 + ride. Mirage 21P SS prop, some dings and edge scrapes. Not really pretty but still runs out fine, great...
  9. Parts for Sale
    400 for the set! They don't leak and have been PSI test. Low hours. Hard to find these. 352 266 1457
  10. Parts for Sale
    ........................................BBC Gil Marine Zoomies with Super Traps. Blued-some surface rust on flanges. $300 Steve phone 760-390-0736..................................
  11. Parts for Sale
    Gil Marine Performance Exhaust and SS Risers HP-500 BBC Low hours. Manufactured by Gil Marine for the HP-500's Includes Stainless Steel Water Jacketed Risers Great Shape. $1500 Travis 951-368-4208
  12. Parts for Sale
    Gil 502 / 454 Magnum Choice exhaust manifolds and polished stainless steel risers for silent choice option. Can be used with boats without silent choice. New oil filter brackets, includes shift bracket and efi ecm box bracket. Wedges shown in pictures are not included. Freshwater use and low...
  13. Parts for Sale
    I think this one may be tough to find. looking for a gil water ski bracket for a BBC
  14. Arizona Dragboat Association - ADBA
    Does anybody have phone number or email addy for him. If you do send it to me in a pm. :thumb:Thanks.................Joey
  15. Parts for Sale
    This a new Gil Marine 10 Qt. oil pan that can be used on an out drive, jet drive or v-drive if snout driven (flywheel aft). It is new and comes with a Gil pickup for this pan. It is a very high quality piece. This is a great buy at $400.00 + shipping. Can take a Visa or MasterCard over the...
  16. Parts for Sale
    I may be in need of a set of GIL stainless risers for a Bravo setup. Need to be in good shape, and need them from a budget minded seller.
  17. Parts for Sale
  18. Parts for Sale
    For sale 1 Hunt-Vertex Mag with tach drive. This is for a 9.8 deck. This is a nice piece, and it is polished. The cap could be replaced, but the inside is very clean. $450.00 obo plus the ride. - Sold For sale 1 new Gil Sea Strainer. It has been modified to make it a right had strainer. It...
  19. Parts for Sale
    I have a pair of Mercruiser Gil HP500 aluminum manifolds with polished SS risers. The risers have silent choice diverters built in with the actuators. They were barely used, a year or two at the most, fresh water only. They will not work on my boat, and I've had them sitting on the shelf for a...
1-19 of 20 Results