Performance Boats Forum banner

hei

  1. Parts for Sale
    ​I'm looking for a HEI Distributor one wire hook up I have a marine MSD Distributor I can trade, if ya have a Nice marine DUI HEI I can't use the MSD cause I have no Ign box.
  2. Parts for Sale
    New BBC HEI ignition and plug wires. set up by John Avery at Engine Dynamics. $750.00 obo
  3. GN7 On the Dyno
    I have a quick question.... I just swapped to a Hei and there is a wire coming from my altenator (yellow) that went to my 12volt side of ballast... Now that I ditched the ballast and coil, what do I do with the wire? Also what does the wire do? Im running a old school original Motorola marine...
  4. Jet Boats
    I have a quick question.... I just swapped to a Hei and there is a wire coming from my altenator (yellow) that went to my 12volt side of ballast... Now that I ditched the ballast and coil, what do I do with the wire? Also what does the wire do? Im running a old school original Motorola marine...
  5. GN7 On the Dyno
    I have been rockin the same dizzy for quite a few years.....locked out. A week or so ago I decided to roll a few more degrees into her to try and make mo powa. I jumped it up to 42 on the light at idle. For what ever reason I decided to give her a little gas. Pretty much immediately it started...
  6. Parts for Sale
    MSD #8365 Distributor, Pro-Billet HEI, Vacuum Pickup, Vacuum Advance, Adjustable Rev-Limit, Chevy, Big/Small Block. TESTED AND ALL CLEANDED up and in good working condition, $190 SHIPPED via USPS
  7. Parts for Sale
    Practically new. $60 FIRM (951) 741-1346 - Jerry Fontana near 15 and 210
  8. Jet Boats
    My jet has a stock 454 (no engine cover)....Would this be a wise choice? Better choice(s)? Street Fire Chevrolet V8 GM HEI Distributor - 8362
  9. GN7 On the Dyno
    I am using a GM HEI distributor on a stock Hardin 454. Do i need to eliminate the vac advance canister and lock it out, or is capping the canister sufficient. if removing the canister and using a lock out plate, do i need to do any thing with the weights and springs? Thaks for any help, as my...
  10. Greg Shoemaker
    Anyone know the wiring diagram for this combo Pro comp to 460 HEI Attached Thumbnails
  11. Jet Boats
    Anyone know the wiring diagram for this combo Pro comp to ford 460 HEI Attached Thumbnails
  12. Jet Boats
    Hey all, I'm running BBC and looking to upgrade my distributor. I'm thinking about going with an HEI. My distributor sits right under the ski tow. My current old points distributor fits under the ski tow however I know the much larger HEI will not fit as long as the current ski tow is there...
  13. Parts for Sale
    Hi, Attempting to build a...frugal......BB with what I have laying around, which includes a tunnel ram and a new in '92 Jacobs ignition system with timing control and rev limiter. I need a small cap dizzy due to tight intake clearance and all I have is GM HEI. Got anything w/electric p/u...
  14. Jet Boats
    Have a 90 Commander with 454 stock, mallory marine distributor with points. Was thinking of replacing points with more modern mag pickup. Nothing wrong with it, just can't leave stuff alone. Did my own fuel injection for the sand car so what's an ignition upgrade on the boat should be fairly...
  15. Parts for Sale
    8 mm wires for BBC $35+ shipping. chev bbc HEI with high performance module w/rev limiter $100 + shipping
  16. Parts for Sale
    Im looking for a good used mechanical fuel pump for a MARK IV BBC and an ignition set up, HEI would work perfect. Im trying to get a boat ready for the 4th. Im using my motor out of my Daytona and putting it into a new boat so I can enjoy summer and do some work on the Daytona. Currently im...
  17. Jet Boats
    Ok so I have a 1973 23' executive with a 455 Olds, I bought a HEI distributor from a 75' cutlass because the old distributor died on me on the water and a boat mechanic out there told me to upgrade to HEI(there was oil inside the petronix electronics) Question #1 do I put the wires back on the...
  18. GN7 On the Dyno
    Any difference in the brands, or will a stock module do just fine?
  19. Parts for Sale
    Edelbock 750 cfm carb-used and working fine $200.00 Performance Distributors Davis Unified Ignition HEI distributor with external timing control knob, 50,000 volt coil etc. Part number ITK13720-used for 100 miles $225.00 Energy Suspension Hyperflex bushing kit for Chevelle, El Camino etc Part...
  20. Parts for Sale
    Just checking to see if someone has a new or gently used marine HEI distributor laying around, such as an MSD, DUI or other. I'm converting from points to electronic ignition on my Carrera Jet. Thanks.
Top