Performance Boats Forum banner

injector

  1. Hilborn injector hat setup and carbon hat

    Parts for Sale
    I'm selling my injector hat setup, I had hilborn freshen it up about a year ago. Its setup for race gas, comes with a river rat water pump too. My setup has all the lines, pumps and bullet tank. Ready to go!!! I'll be at billy b's next weekend and can bring it with me. 2500$ Also for sale is...
  2. Enderle Buzzard Injector

    Parts for Sale
    Sold
  3. Hilborn Shotgun Injector Hat (Polished)

    Parts for Sale
    Polished Hilborn Shot Gun injector hat 5.250" dia. butterflies. This hat has been line bored and brass bushed with splined shaft ends for smoother operation, provision for Hilborn or Enderle barrel valve, drilled for distribution block on the rear. From mounting surface to top of injector is...
  4. (Wanted) Mr Gasket injector style scoop for 2 four

    Parts for Sale
    Looking for 2x4 carb scoop old school injector type thanks
  5. [SOLD] Crower Shotgun Injector

    Parts for Sale
    Crower - Magnesium 8 port fuel injection hat, includes lines but no valves or metering blocks. All good condition and no issues. GARAGE SALE PRICED -$2000.00 Paul
  6. Injector/ fuel pump recomendation

    GN7 On the Dyno
    Hope everyone is well! I took a season off from the boat after getting the new engine in. Wife's new job had her travelling a lot, close family member is battling cancer, and I found other people's boats to ski behind! This winter I am hoping to start moving to getting the boat fuel injected and...
  7. Eng. Parts PSI Deepthroat Mag Fuel Injector

    Parts for Sale
    PSI Deepthroat Mag Fuel Injector, Polished, With Deepthroat billet lip, Used, $1,500
  8. [SOLD] SBC Hilborn Injector

    Parts for Sale
    SBC Hilborn Injector SOLD!!!! Old school Hilborn. Been sitting forever. Throttle shafts free and tight. Manifold is nice, with lots of patina. Appears to be plumbed for self prime. Barrel valve, nozzle size unknown.Gas or Alcohol? Don't know that either. $500 as is. 414-750-1917. Pete.
  9. SBC Hilborn stack injector, no pump, $750

    Parts for Sale
    SBC Hilborn stack injector. No pump. 8.75" tall splayed and belled stacks, #14 nozzles, barrel valve and all lines and throttle-shaft linkage. $750. [email protected] or (949)248-0083
  10. Enderle Buzzard Injector

    Parts for Sale
    like new with fresh polish and new black blades. S.S hard line included. Nicest one you will ever see. $600
  11. Polished Enderle BuzzardCatcher blower injector

    Parts for Sale
    Polished Enderle BuzzardCatcher blower injector with red blades. Comes with K-valve, distribution block, stainless lines, nozzle bodies, nozzles (most in the 50's range), main fuel line and all throttle-shaft hardware and linkage. $800. [email protected] or (949)248-0083
  12. shot gun injector

    Parts for Sale
    looking for a used shot gun with or with out barrel valve and lines.send pm with info.thanks
  13. wtb injector set up

    Parts for Sale
    looking for buzzard or bird catcher hat with lines barrle valve pump ready to go
  14. enderle BAU 5 9/16 injector

    Parts for Sale
    full polish enderle BAU 5 9/16 hat , shafts , fly's and stops ! no barrell valve , about a year old with 3 trips to the lake , zero damage ! these sell for $1499.00 plus tax and frieght ! going different route , $1150.00 shipped
  15. [SOLD] BBC Crower/Kinsler 2.9 Alcohol Injector

    Parts for Sale
    Crower /Kinsler injector set up for alcohol. Not run since flowed by Spud Miller at Fuel Injection Enterprises. Complete with pump, bypasses, jets, cover and paperwork. Ready to go to work. Located in Southeastern Wisconsin. $2000. 414-750-1917. Pete.
  16. bds bug catcher hat and efi 8 injector plate for 12-71 or 14-71 blower

    Parts for Sale
    this is a decent bug catcher hat that is sitting on a 2" thick bird to bug adapter plate that has been machined for 8 efi injectors. fuel rails are included. fits 12-71 or 14-71 with 15" top opening....$600 plus shipping. my computer will not let me upload pics right now. will be happy to text...
  17. Hilborn Injector w/Scoop

    Parts for Sale
    Original Hilborn 4-port mechanical fuel injection with original Hilborn magnesium scoop. The injectors are set up to run methanol/alky and does not include the fuel pump. Asking $1500 for injectors and scoop. Blower is already sold!
  18. [SOLD] Hilborn Shotgun Injector

    Parts for Sale
    This is a used shotgun injector. It is an older one. I ran it 25 years ago and it was used then. It worked well for me and was on a pro street nova for several years and performed great. It needs to be polished and there are some places on the shaft where the chrome has come off. It comes with...
  19. Injector

    Parts for Sale
    R&R upright injector with carbon fiber scoop No BV . $ 1000.00 Derek 559-799-0097
  20. Billet Blower Injector

    GN7 On the Dyno
    Nasty Dave Benjamin machines these. He and Tommy run them on the AA/FA and the Nostalgia Fuel Funny Car.
Top