Performance Boats Forum banner

inlet

  1. V-Drives
    What is this type of inlet called and where can I get a new one since my plates are pre drilled for it and this one is beat up pretty bad ??
  2. Parts for Sale
    Sold Sold thank you
  3. Jet Boats
    Never liked the "metering"valve, but it worked and seems like lots of people use them to limit the water psi. Recent pump changes have increased the psi too much and a true regulator is needed. What do you guys run? What is the optimum water psi? (18-25?) Thanks. pic of old valve....
  4. Parts for Sale
    SOLD, SOLD, SOLD 5" inlet Gibson Clamp On Muffler with flappers, Used one season fresh water. $375.00 DETAILS Teague Custom Marine Bullet 5" Performance Mufflers - Gibson Superflow Mufflers - Mufflers Tips & Parts - EXHAUST Tested on 502HP, 500HP, 525HP, 575HP up to 1,200HP. Reduces decibel...
  5. Jet Boats
    just want to be sure my logic is right... on the line coming from the pump to the engine, with the ball valve in it: Put a fitting before the ballvalve that I can screw a hose into?
  6. V-Drives
    V drive river boat, blown 572, magnaflow pump. Is a single -8 pick up and line to the pump enough?
  7. Jet Boats
    Can anyone tell me what size the water fitting coming from my Berkeley pump is? The actual threaded hole in the pump housing. I am assuming it is a 1/2" pipe thread but want to clarify that before running a tap to clean it up. Thanks for the help!
  8. Parts for Sale
    I am looking for some water inlet fittings for a 426 hemi. Does anybody nowhere to find these?
  9. GN7 On the Dyno
    I need a couple fuel inlet adapters for the new 6109's I built. They have 4 side hung primary bowls. I am placing what I hope is my final order for the last little stuff and I do not know what the thread size is for the bowls. The OD of the threads for the 2 6AN fittings I have that fit are...
  10. WFL Crew
    I'm rebuilding a 18' earl smith. I decided to use tramsom plates, but the pump has the stock set back. The transom cuts across the middle of my dominator inspection plate. Anybody have pics of how they got water thru the transom off the pump? There are only about 3-4" to work with. Not alot...
  11. GN7 On the Dyno
    was wondering how efficient the new intercooler worked on the jet. Any inlet temps or water pressure drop info?
  12. Parts for Sale
    NONE AVAILABLE NOW THE PAIR ARE SOLD. Thanks Mark.
Top