Hey, all you peeps that can't log in!I may have found some help for you, not that kind, if you still can't get thru the robot and get a new password, please read below and DO IT
Don't whine about it, do something about it. :thumb: Thank-you Performance Boats. (This was posted 12/14/2018)
I may have found some help for you, not that kind, if you still can't get thru the robot and get a new password, please read below and DO IT
Don't whine about it, do something about it. :thumb: Thank-you Performance Boats.
I'll need more info to look into this. What specifically...
Finaly wore out the Nicson exhausts and need some new ones. The boat is a 21ft Howard v-drive cruiser with a 468 11:1 closed chamber rect port heads and an 850 Quickfuel carb. The motor will be under an engine cover.
Im trying to figure out the best route without going back to the logs. The...
exaust log turn downs ...$100 shipped
think these were set up for twin turbo motor........has some extra water inlets/outlets i dont know..
.....can be plugged and used on reg logs for a old school flattie...
I had a fairly good leak from shaft log last summer, checked the bolts and everyone of them was loose. Tightened them up but 2 are stripped and I still have a very small leak in that area. I'm going to pull it up this weekend and fix it, what do you guys use to seal it back down? Or does it...
Up forsale motor plate with feet ,front feet are still in boat just not in pic. $200 negotiable on price and shipping exhaust logs with snails $ 150 negotiable on price and shippingtiming cover with water block off plate $40 negotiable on price and shipping
1 " nicson strut ....$25
1" water cooled shaft log ...$25
new nicson single fin (no holes)..$10
+ shipping usps flat rate box
or take all shipped to your door $65 paypal
As the title says, looking for downturn exhaust elbows for a water log exhaust system, BBC. I want to run thru-transom exhaust but the snails I just picked up run right into the back deck of the hull! I currently have glenwood manifolds.
Located in Reno.
So I bought a v-drive with a cracked Glenwood exhaust log with over the transom pipes. I have a set of Nicson exhaust logs that I can use but they have the through transom elbows on them and I can't get them to seperate from the main exhaust log. They've been together probably since 1972 when...
How do you put an oxygen sensor in a log manifold? I have not been able to find anyway to do it at all. I was hoping that someone made a spacer that fit between the snail and the log with a bung in it but I haven't been able to find one. Does anyone have any solutions?