Performance Boats Forum banner
1-16 of 16 Results
  1. Tow Vehicles, Cars and Parts
    Sold Helping my aunt sell her camaro. She has had the car for the last 28 years and will not be able to restore it back to what it was. The car is apart but all the parts are there. SS 350 ac car with a power glide the red is not the original color it was a turquoise with turquoise interior...
  2. Parts for Sale
    FS: Matching Holley 4779 750s, BBF T-Ram I have a beautiful matching set of freshly rebuilt Holley 4779 750 DP carbs, mechanical secondaries, rebuilt by Stahle Performance and powder coated. Offenhauser BBF tunnel ram with carb adapters for running the carbs sideways. Carb plates have been...
  3. GN7 On the Dyno
    First timer here. Before I ruin my new manifold. If I remove the material were marked will this be ok? Also do you trim off gasket that will be in the valley? ( If it's the right gasket going the right way?) Trying a rebuild and want to get all the grinding done. Thanks for any help. Johnf:)Unsure
  4. Parts for Sale
    Victor Ram setup with dual 4150 top and matching dooley scoop. Polished but could use a fresh buff. $350.00 plus shipping.
  5. Paint and Fiberglass Repair
    I have a large repair area on my hull that is ready for gelcoat (using a sprayer) the original color is light gray. I made numerus samples using white gelcoat with black tint but I can't seem to get a match! Is it possible that boat manufactures start off with neutual or clear gelcoat and then...
  6. Parts for Sale
    Looking into repowering with 300xs just because i run so much here in southern california its worth it in fuel. These 1998 300 promaxs are meticulously maintained. One motor has had a new powerhead put on it 100 hours ago and the other is the original with perfect compression and 850ish hours...
  7. Jet Boats
    June 27, 2012 Hello People, Just making a few adjustments so we can run past the 8.o’s in to the 7’s. :)Unsure The hardware is being config now and it’s looking good for the September race.
  8. Boats for Sale
    19' Millerr jet boat with matching trailer $1900 1985 miller 19' jet boat tandem axle trailer with matching fiberglass fenders has mount plates for big block chevy and berkeley pump, steering, foward reverse handle and cable, 2 aluminum tanks with fills, wire harness clear titles for boat and...
  9. Other Stuff for Sale
    Looking for a matching pair of seadoos/jetskies 2006 or newer... Whats out there??? Norcal area
  10. GN7 On the Dyno
    OK , here's the deal. I am reasembling my bbc 427 and am matching intake to heads . Now years ago when I first built this combo I didn't really care much about port match as long as the blower manifold port was smaller than the heads , thinking there was now step for the air to trip over. Now...
  11. GN7 On the Dyno
    Its been discussed here before and generally accepted the best way to set up rocker geometry is based off mid lift angles. So is there a lobe profile that takes full advantage of this ?
  12. Parts for Sale
    Bravo1 Props 32p matching Pair, larger XR hub, can be adapted to smaller hub. Matching set $600 obo sold as a pair
  13. Jet Boats
    Anybody know were i can get some gel color matching done by people who really know what they are doing? Shurfab or whatever they are called is no longer owned by the same guys. I got a match done by them and laid some of it out today and it's not close enough. When talking to the guy who...
  14. PB Open Water
    Trying to find beach towels to match my boat. Where do I go:)
  15. PB Open Water
    Alice has been watching the Mecham and other Muscle car auctions on TV. She loves performance. She loves GM, loves the auctions. I'll get right back to that. She also loves our high mileage 8.1 GMC and so we ordered a spare (smog compliant) crate motor from GM (because you can't buy the 8.1...
  16. Boats for Sale
    21' 1980 V-Drive, 454 n/a single carb, turbo 400, new interior in 04' from Schiada, 2004 Ellis Trailer, just gone through by Lee at Schiada. Matching striped Custom Canvas cover. $40K - financing available. 10' 1985 - in process of being painted to match the 21 so needs to be reassembled...
1-16 of 16 Results