Performance Boats Forum banner

mighty

  1. Boats for Sale
    Putting the mouse tunnel up for sale if anyone is interested.ill post pix to this thread from tapatalk app in a few. 16ft 300lbs mantra race tunnel twin 70mm intercooled blowthru pumpas 1000hp ls 325ci, low cost to run and maintain.rock solid fuel system capable of 1600hp, msd c.o.p ignition...
  2. Trailers and Trailer Parts
    22' x 8.5' 2008 Mighty Mover Trailer 7000 GVW Custom server doors both sides Radial Tires Less than 200 miles total Sprayed bedliner floors and 3" up the walls. Easy wash out Belly pan in floor for storage New battery Solar panel charging system Electric Tongue Wood cabinets and Bell Tech...
  3. Parts for Sale
    Gotta get a bigger carb so this one has gotta go...Mighty Demon 825cfm...hasnt run for approx 2 years, and has been sitting bolted to a manifold with a lid on it on the shelf in my garage....what you see is what you get.... I would like to get $275 plus the ride....I am located in Ceres, Ca...
  4. PB Open Water
    Went up around the Bartlett Lake area today. This is an FAA radar on what is, as near as I can figure, Humbolt Peak. According to the GPS we were up around 5300' and it was plenty windy once we hit the top.
  5. Jet Boats
    Looking to get a good out of the box carb for my mild 327 sbc jet boat, is the mighty demon 650 mechanical secondaries a good carb? I have a 750 eddy now and hate it, cant handle the 9psi that my fuel pump delivers and it has a bad hesitation when the secondaries open.
  6. Parts for Sale
    I have 2 Barry Grant Mighty Demon 850cfm carbs. Annular discharge. P/N 5563020GC This is the perfect replacement carburetor for old muscle cars, street rods, performance applications and high output crate engines. Designed for engines with cam profiles up to 260 degrees duration at 0.050"...
  7. GN7 On the Dyno
    okay fellas here is my questions the motor i built for my uncles lp is doing great:D it has a rpm air gap and a 1inch open spacer. 850 mighty demon{not my choice but does good nevertheless;)} okay here is the problem.i ran it hard this evening.pulled plugs #1 is to rich-#2 is bout right all...
Top