Performance Boats Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 39 Results
  1. Parts for Sale
    I Have 4ft of MPI 110-1000, INTAKE 1" hose Premium marine hose New never been installed, I bought it by mistake, I needed 3/4" $15.00 + ride Call 530 575-5025
  2. Bob Teague
    Have a 2006 Crownline 225 LPX with a 350 mag, captains call, with Bravo 1 with the 2 point quick drain that is overheating at idle. Have replaced the thermostat, impeller, engine water pump and finally the whole raw water pump. Starts up, temp rises to 180 and all seems fine. After a minute or...
  3. Parts for Sale
    i have a 2200 CFM throttle body for use with Muli-port injection. it has the TPS and Iac sensors on it and throttle linkage . asking 400 bucks it's the Raw/polished finish and looks like it's new or almost new.. excellent shape. i can not use this in the car im building and forced to buy a lower...
  4. Boats for Sale
    2007 LaveyCraft XTSki 6.2 Mercruiser - 320 hp Mercury Bravo 1 outdrive Twin tanks which hold around 15 - 20 gallons each. 22p prop and top speed is about 55 - 60. Around 180 hours, oil change and impeller done every year up at Nordic in Havasu regardless of hours (usually 20 - 40 hours) Never...
  5. Parts for Sale
    i'm getting this with a deal i'm will be in my possession this weekend 4500 obo
  6. Parts for Sale
    Complete efi system for 502 Magnum MPI $800
  7. Outdrives
    I'm thinking of replacing my stock Merc exhaust manifolds, any recommendations? My engine is stock, other than a K&N air filter.
  8. PB Open Water
    Much appreciate any ideas/assistance in advance... I just bought a 2006 Carrera jet boat with 496 MPI motor and a Dominator jet drive. The motor has about 90 hours on it and for the most part the motor runs great with great throttle response and smoothness that you would expect from a...
  9. Parts for Sale
    I want to buy a complete 502 or 454 mpi mag engine and bravo 1 drive
  10. Parts for Sale
    502 MPI Complete vortech (like procharger) Supercharger kit Hi, I have the following for sale in great condition. Complete livorsi/graffig extreme supercharger kit. Polished Vortech V2-S SC Polished Intercooler, re-programmed mefi 3 ECU and 2 bar map sensor included ready to run! fuel pump and...
  11. PB Open Water
    Hi folks I have been reading allot about this motor package and just my luck I find the boat that has this beat motor package. But my never quit Block Head attitude is keeping me going. Here's what Ive got I found a 99 Falcon 2500CD stored for years. I understand its a low budget Formula but...
  12. Parts for Sale
    Looking for a good running 454 mag or 502 mpi Gen 6 motor preferably complete.
  13. Parts for Sale
    Complete m1 procharger including intercooler for Mercruiser 454/502 MAG MPI motors and the complete mpi intake, harness, ECU. Everything you need to turn your carb big block into a boosted fuel injected beast. 2750$ Please call (503) 740-5472
  14. Boats for Sale
    Hull is a 1988. Interior is in nice shape. Its Black and gray striped like the hull. Boat has a new engine with 14hrs. Fuel injected. Outdrive is a brand new Alpha spin off. It has a drive shower and 17 and 19 pitch props. Quicksilver stainless. Its a good looking and easy riding boat. Decent...
  15. GN7 On the Dyno
    Looking for a complete 496 or 502 MPI
  16. Parts for Sale
    looking for a complet 496 HO or a 502 MPI
  17. Parts for Sale
    Mercruiser MPI magnum fuel injection complete BBC came off a Gen 6 502 magnum but will work on any bbc, we went 8-71 blower so no need for any of this, also have the mer PM/text/or call and make me an offer 626-991-2129 eric parts are located in Covina Ca i can deliver to most of so cal
  18. Parts for Sale
    These are 2 complete sets of Mercruiser Fuel Injection intake manifolds and plenums from a pair of 2000 model year Mercrusier 502 MPI engines. They are compatible with the Mercruiser MEFI 3 electronic engine control system. They were removed from working engines as part of an upgrade to...
  19. GN7 On the Dyno
    We have a 91 cole superhawk with a 7.4l mpi engine that was swapped in by teague marine. Having some issues with what ive read on previous threads being vapor lock. Boat will run for awhile and then just die. Will crank and crank and not refire for awhile. It has the cool fuel system already...
  20. Parts for Sale
    merc 454 mpi with side mount wipple comes with everything less exhaust refreshed 2 seasons ago, pushed my 25 daytona 90mph. call or txt if intersested kyle 951-442-0542 located in riverside
1-20 of 39 Results