Search Results for ‘pads’

I still need a nice set of cavitation plate turnbuckles and lower pads... Anything out there?

Stainless turn buckles and pads. Length in their current position is 7 3/4" pin to pin. 3/8" diameter threaded shaft, 2" pad. Please note that there are two of one style and one of the other style. $50.00/offer shipped.

8 Turnbuckles $200, 16 S.S. pins $20.00, 8 plate pads (4 hole style) powder coated black $100.00 or take all for $300.00. Shipping is on you. Rob (509)342-1705

I'm looking for a turnbuckle around 6.5 long eye to eye. and two pads. cp is back ordered, pic included

These V drive cruiser pads were pulled from a V drive Shiada years ago. I will never use them. All I ask is $15 for shipping I want nothing for the parts but please make a donation amount of your choice to ~ strike out cancer. https://www.jasonmottefoundation.org/donate.php First reply gets...

I need two turnbuckle pads like this.

Anybody looking for some new brake pads for a Dodge? I bought too many.... I have a whole set front and rear all four wheels for $25 can ship USPS flat rate for $11 or bring them to Needles for you too. C-TEK Metallic Brake Friction C-Tek Metallic brakepads offer excellent pad and rotor life...

Upgraded to ssbc set up so I have just sitting and taking up room 75$ for everything

I have 8 polished brand new flat pads. Have had these for years. No bushings. 175.00 OBO free shipping. 909-670-8058 Call no PM's please.

Bob - Please take a look at this thread on the setup of an old GN Boat... http://www.performanceboats.com/v-drives/103573-unusual-placing-plate-hardware.html

I decided to upgrade my cavitation on my 76' Hondo. The plates are the standard 9'' past transom. All the turnbuckles are in good shape and the plate pads are also. 8 turnbuckles/ 8 plate pads and 3 plates. Call for any measurements needed. $150 bucks takes it all. Call me (310)508-3048 Wayne

I am looking for a set of 8 clean 3/8 single bolt cav plate pads for the kids boat, anyone have any for sale ?thnx

I'm redoing (trying) the floors and I need to remove the tank pads.. (I'm not going to run them when its done) I cut most of the top layer of glass out of the floor with a small skill saw and a dremel tool with a cutting blade and its working pretty good except at he pads due to the thick...

I have a 77 Bubble Deck that I am trying to get the gas tank pads out. Seems to be glued down with some kind of adhesive, any suggestions on how to get them out? Been prying on them but them suckers are stuck good. What kind of glue they useing seems like good stuff might need to use some to put...

Just wanted to give Mike from Vintage Rod Components props for their "show finish polishing pads". He sent me some samples and I used them on my tunnel ram and my valve covers. These things are bad ass. They gave my stuff an awesome shine. Here's the link Show Finish? Metal Polishing Pad...