Performance Boats Forum banner
poly

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Parts for Sale
    I know its a long shot but I got an oldie with a 1967 Poly 318 in it. I need a 4BBL. Manifold for it. Iron or Aluminum I don't care. No other small block Mopar will fit it. It has to be a Poly motor manifold. Not having much luck. I know they made them but haven't found one.
  2. Other Stuff for Sale
    Clearance sale on the last batch of new SynTec 30 round mags...anti tilt followers...tab on bottom releases (just like a PMag) for maintenance and cleaning...new price $17.50 ea + shipping any quantity while they last when these are gone they're gone...Will ship where legal and to Cali as a...
  3. Parts for Sale
    new never ran...40 bucks plus shipping from 84044
  4. Parts for Sale
    RCD Gates POLY CHAIN GT 8MM 1600 KEVLAR BLOWER BELTS These are used belts but are virtually like brand new... Came off a top fuel car after 1 pass each. CORRECTION: Belt is 63.5 inches long and 200 tooth count $300.00 for all 4 of them or $85.00 each + the ride...
  5. Parts for Sale
    Intake Sold, Still have the poly locks... Also 2 sets of 7/16" poly locks with 0.600" bodies and set screws. One set new from Crane, one set with dyno time only from Crower. Either set $25 to shipped priority mail to your address. No pics on the poly locks, you know what they look like. If you...
  6. PB Open Water
    Wondering if anyone knows of a supplier in the Ventura or San Fernando Valley area that carries sheets of the 1/2" white "marine lumber". Some of the production boat companies like Chapperal use it for the seat bases instead of marine plywood. I think they refer to it as polyethylene.
  7. GN7 On the Dyno
    What will cause this???? Just installed a set of jomar stud girdles, thay have about 3hrs on them. The poly locks suck:mad: I think I need new studs as well
1-7 of 7 Results
Top