Performance Boats Forum banner
1-14 of 14 Results
  1. Parts for Sale
    Looking for gale banks, Rajay, rotomaster twin turbos for a bbc whit E Trim wheels
  2. GN7 On the Dyno
    Barry was hoping you could help ID the pipes, what setup would these have been for race/aero exhaust manifold Im assuming the water fitting goes on underside of pipe the water exist some holes at end of pipe, assuming holes are at top inside of pipe getting down to thinking about the the turbo...
  3. PB Open Water
    I got a 1980 25 ft centurion 454 with twin turbos I am looking for rajay turbos, anybody got turbo parts and pieces?
  4. Parts for Sale
    2 Rajay turbos off of a Gale Banks system for sale. $800 for both. If interested contact Eddie 520-400-1423
  5. Parts for Sale
    Looking for RaJay turbo wastegates similar to those shown in the attached photos - A machined block between the riser or manifold and the turbo exhaust housing flange with a provision for a newer wastegate. I imagine these were a custom piece but maybe someone has something similar. PM me should...
  6. Parts for Sale
    2 - rajay turbo's for sell - 2 complete rebuilt with polished water cooled heat shields - $1,400.00 for the pair - OBO 1 - used rajay turbo tight and spins free - $400.00 - OBO 2 - used exhaust housing with 3/8 bypass hole - $150.00 for the pair - OBO I can email more pictures Thanks
  7. Parts for Sale
    I am looking for a good 1.0 turbine housingfor a Rajay turbocharger. This is the cast iron part that attaches to the exhaust manifold. Call Jim @ 817-457-4237
  8. GN7 On the Dyno
    I was wondering if anyone had a spare Rajay turbo with bypass hole for sale that I could send of and have rebuilt. I had mine gone thru last summer but the same one just puked out the gasket again between the aluminum intake flange. The flange must be warped or something because it is the...
  9. GN7 On the Dyno
    RAJAY TURBO? I have been trying to learn more about the Rajay turbos. I have a Race Aero turbo set-up on a BBC 454, and have been trying get a handle on the various sizes that were made and how to determine that by the Model number. Is there a chart that explains how to compare the sizes...
  10. GN7 On the Dyno
    Is there a source that can explain how the various Rajay turbo numbers compare and what each set of numbers mean? Specifically, how do the Rajay 301 E 10 and the 370 E 70 compare to each other? I was told they are essentially the same. Yes, or no?
  11. GN7 On the Dyno
    Looking for rajay parts or complete turbos, thrust bearing went out in one of my turbos, 301e rajay, thanks brent.
  12. Parts for Sale
    Thrust bearing in my rajay went out, need replacement parts or turbo, anyone holding on to some of this stuff looking to get rid of it. Thanks brent.
  13. GN7 On the Dyno
    i havel posted the actual parts that i have needed to give some additional help . dont break the carbon seal ,i think thats the $345 part if i remember right . you can see on the list that they gave me a deal on the prices,probably 'cause i told them i wasn't an airplane owning highroller & it...
  14. V-Drives
    I'm total newbie, so if this sounds dumb go easy on me... It's a Race Aero setup with Rayjays. I'm going to want to go through hull on my setup. I think I can start with my current tailpipes and jacket them. Or can I skip jacketing take the easy route and just inject water instead...
1-14 of 14 Results