Have a Long list of parts here.. most intqake manifolds are New or like new. all parts were from a Machine shop from customers not paying for orders..
1. Air Gap intake # 7501 single carb like new or new 125.00
BBC intakes single carb's
2. BBC Edelbrock Victor JR intake Req...
I have two (2) Polished Imco SR-8-1-13 Hydraulic Rams with Cleavis ends and 90degree fittings installed. They are in good working order. No leaks. I can email you pics. $500 or make an offer for both! [email protected] :partyguy:
FTN race. Nozzle in good shape,was chrome and peeling in spots but over all mechanical is very good. No big gouges or any casting problems. Has rams horn reverse bucket and bolt on rudder get picks up soon 225 shipped.
I have a 1978 bass boat, 150 Merc with dual trim rams (Part# 79114A4) and a Prestolite pump (rectangular reservoir with a fill and air bleed screw) and the valve body/gear case mounted to the bottom. The engine would slowly fall to the full down position after being trimmed up. When running the...
I have a few nicks on the upper drive casing paint and the rams that actuate the tabs.
Id like to touch them up with the right paint/enamel.
What paint or other substance should I use to touch this up?
Brand New in box, 12" hatch rams. I got these from Fountain a few years back. They're hatch rams for a 35 but will fit others. I was going to use them on a Cigarette project but went a different direction.
$200 for the pair.
So I have decided to get some add on steering for my single Bravo X outdrive here in the near future. All the pictures I see have the rams mounted about a foot or so outside the outdrive housing inline with the crank centerline. My exhaust is in this location. The outer flange of the exhaust is...