Performance Boats Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. Paint and Fiberglass Repair
    Need my Stoker 20.1 trailer blasted/painted....diamond plate replaced ASAP.... Any recommendations in the Vacaville/Sac general area? Thanks in advance !!!!!
  2. PB Open Water
    So the Twin turbo setup I am putting in my boat wont fit unless I get rid of the power steering bracket and pump. So I want to go Full Hydraulic Steering. Which is the best brand? 1989 Checkmate Maxxum 229 with Bravo 1 outdrive. Thanks for the input. Jason
  3. West Coast - North
    Can anyone recommend a good outboard mechanic? I have a 1985 150 mariner, I'm located in Richland Oregon, looking in Ontario Oregon, Caldwell Nampa or nearby. Thanks
  4. Off the Water
    Im considering a job 80 miles away, one way. Im looking for a commuter car. Something cheep till I make probation (12 months), thats easy on gas 30+ mpg if possible? What are you driving, or what do you recommend? Thanks, be safe. schick
  5. Jet Boats
    Since Jim is close to my home I was able to go meet him. I needed a few parts and I did my research. I've spent a lot of cash with 3 places now, Jim at Cyclone, Duane at HTP & Tom at JBP. In my opinion all equally good at what they do and all offer as much free advice as you can handle. None of...
  6. Jet Boats
    Getting ready to wire up my boat and want to run a battery disconnect switch. I'm running just one battery. What are you guys all running that seems to work for you. Also remember, this is Washington so it may get wet as we drive in search of sun.... :raining: Thanks guys.....john
  7. PB Open Water
    Looking to spruce up the system a bit and was wondering who you all go to? Thanks! :party1:
  8. PB Open Water
    How many hours do you put on your boat before you closely inspect the entire outdrive? What does the manual suggest about servicing and inspections by a Mercury authorized service center.
  9. NorCal
    Howdy, It will be great to finally get back into boating, but unfortunately I need first start from where I left off. When I packed the '78 BBF Eliminator Bubble away TWO seasons ago, the very last gauge that was working finally stopped working like all of the rest. When I bought it, only...
1-9 of 9 Results
Top