Performance Boats Forum banner

reference

  1. Need to Boost Reference Dominators

    GN7 On the Dyno
    Does anyone know of a carb shop in Ventura County, CA or the San Fernando Valley, CA that can do this? Have two 1050 Dominators on a 540 with 8/71. I know that Performance Carb and Speed in Ontario, CA can do it, but I was wondering if there was a shop closer to where I live in Ventura. I'm...
  2. [SOLD] Carb Shop Boost Reference 850's

    Parts for Sale
    Older pair of carb shop boost reference 850 Holley double Pumper just kitted, ran a few times switching to EFI setup 700 + the ride 951 545 4425 Steve
  3. building a brpv setup using hat stud for reference on blowthru carbs

    GN7 On the Dyno
    I keep gtn pm's about a post i made modding my qft carb to use hat stud for the signal to the powervalve.barely have 3g connection at home so if someone is interested in me goin thru the motion of showing peeps how to do it yourself for under a buck gimme a pm and ill take my carb apart tmrw ...
  4. 496HO Fuel Pump Cross Reference

    PB Open Water
    I need to replace my Low and High pressure Fuel Pumps on my 496HO with the Cool Fuel Cell. Does anyone know if there is a cross reference for these pumps in the after market world like Airtex. I'm pretty sure these are not Mercury pumps. The mercury part numbers are: 866170A01 (Low) and...
  5. South OC Landscape/Gardener Reference

    PB Open Water
    Looking for references for a landscape gardener in Laguna Hills area,someone that can do more than cut grass and go. Thanks in advance,
  6. Trailer Modification Reference

    PB Open Water
    Looking to modify my boat trailer to add a swing away or removable tongue. Recommendations in Havi? Thanks- John
  7. Gray Dodge, OP6C, Stoker sticker, river reference on lic plate

    PB Open Water
    Anyone know who this is? I think I've seen them on the boards. They probably live in So OC.
  8. boost reference question

    GN7 On the Dyno
    ok...here is the setup... 454 bored .60 over. Aluminum GM Bowtie rectangular port heads # 14044861. These heads have 380 CC runners. They are 106 CC open chambers. They have been angle milled .125. I used cometic head gaskets...051. Pistons are TRW L2377 .60 over pistons. Intake Manifold is...
  9. boost reference or not

    GN7 On the Dyno
    do i need this? I have talked to some people about this and have been told i can take the power valves out of my 750 DP's and do the same thing? i found some for good price and need to know what to do. the ones i found are 750s with boost ref and i have 750s without. Thanks Nate
  10. Holley 750's w/boost reference

    Parts for Sale
    2 Holley 750's with boost reference. Used 1 season after rebuild from Performance carburator $600
  11. Boost/Vacuum reference port question

    GN7 On the Dyno
    Can someone explain these ? I'm upgrading my mech fuel pump to a Clay Smith which requires a regulator (my old Holley did not). Do I need a regulator with a boost/vacuum port ? Why ? Can't I just set the F/P at 9lbs. and go ? Thanks !!! P.S. Blown BBF running +9 lbs. on 92 pump.
Top