Search Results for ‘running’

Up for sale is above mentioned Factory EFI System, Complete with all harnesses, computers, sensors, ECM, CDI's, Flywheel, intakes, manifold, fuel rail, injectors, stator, linkages, brackets, vapor canister/fuel pump and all hardware. Came off well running 2000 200 EFI Mercury 2 stroke. Went with...

This custom bike is Awesome with low miles, I just like boats a bit more and Really want a pleasure boat to cruise around on, so my Placecraft can be full rcae :)

Need Running SBC 350 please PM with what you have Tom

I have a question for the wizards. I have a magneto on my pro stock boat engine with an internal coil. Can I run an electronic type of tachometer (Autometer) off of the mag with the internal coil or do I need a mag with an external coil to make it work? There is only the kill wire coming out of...

I Like the look of these rewarders but also really like the look of these custom made headers aswell would like to see pics for ideas please I will be running a big block Chevy

just getting eliminator going, have hose setup to run out of water, has turbo 400 trans, so shaft(no prop now) spins in neutral and checked trans operation, heard bad wine sounded like stuffing box. It has a a water dump hose from V drive but on hose no water, is it not a good idea to run out of...

Want to fire off the motor in the driveway for a maybe 5 minutes and check for fuel pressure/leaks. I have never really ran it on the hose and I don't know if you should turn the water on first and let it start to fill the block and then fire the motor or fire the motor first and then let the...

I have had these same symptoms on 2 engines, old mostly stock 454 and the new 476. With the pump outlet valve all the way open the engine runs at 150 idle and 130 cruising, if I close the valve at all it gets hotter. I have checked everything but the wear ring. Turning the pump over by hand it...

now i have afr aluminum heads and they said to run an autolite 3932 not sure if thats a colder plug was curious what you guys think 468 bbc tunnel ram with with 750s 10/1 compression msd 6 running 93 octance timing at 32 degrees

Looking at installing one of these soon , so what's the preferred deal ?

I'm thinking about running a v drive box in a 4x4 rig. I'm sure I'll need splined shafts with yokes instead of keyed smooth shafts, maybe 1 to 1 gears? I need a reverse rotation gear box to run a rear engine setup. would one hold up in a mid size rig? any advice or line on parts would be a big...

So I'm running out of fuel on top end.BBC 468 with 2-660 holleys on tunnel ram with Holley fuel pump and regulator but can't tell the size of pump. Half inch lines running to pump and regulator the separate 3/8 lines to each carb. 8lbs of pressure at idle and pulls real good but runs out on top.

For a big block chevy... not blown.... are you guys running mechanical pumps still? electric pumps? if electric, is there a common one people like and where are you mounting it? Pictures welcome! :partyguy:

I was heading to the local sand bar and ran my Taylor SJ jet boat with a 505 maybe three or four miles and I noticed that the engine temp was moving up. It normally runs around 180 on the temp gauge and when it shut down it was at 220. It died on me while running about 3k RPMS and I had flames...

Talked to Dave at Liberator about doing a Calgo conversion on my boat , he said all his new models come out now with Power Steering and it's the cats ass ? :)Unsure Anyone else have PS in their Jetboat ?

I'm rigging my 16ft Hondo and I've hit a small snag. The "marine" battery that I've run in my last hull is kind of bulky. The Hondo is a little more cramped than the hulls Ive ran in the past. I want to build a mount to place the battery on top of the stringer near the transom. The battery I...

running https://www.youtube.com/watch?v=8lCVPZ7Qths

Like this , Engines