Performance Boats Forum banner

sealed

  1. Jim Wilkes
    This may not be the right place to ask this, Will New Sealed, Empty below deck gas tanks collect condensation installed in a water proof covered cruiser parked outside in winter ?? Some will say do not store the boat out side, The Garage is needed for something else for a couple of months
  2. Parts for Sale
    Never opened brand new. I have 2 $135 shipped in lower 48 Jason call or text 818-698-5174
  3. Outboards
    I have a 1978 bass boat, 150 Merc with dual trim rams (Part# 79114A4) and a Prestolite pump (rectangular reservoir with a fill and air bleed screw) and the valve body/gear case mounted to the bottom. The engine would slowly fall to the full down position after being trimmed up. When running the...
  4. Trailers and Trailer Parts
    THESE ARE SOME RED LED TRAILER LIGHTS I HAVE JUST LAYING AROUND THE GARAGE I NEED TO GET RID OF. YOU CAN EMAIL ME IF YOU HAVE ANY QUESTIONS.
  5. GN7 On the Dyno
    :)handRod and main bearings. A Series rod bearings and MA Series mains. Bi-metal bla bla bla. Would they hold up in a boat motor? Thanks.
  6. Pro Zone - Items for Sale by Businesses
    I made up some new (off and old design) 1" prop shaft log seals. They are made from 6061-T6 aluminum with a machined finish. They are 2 1/2" diameter by 2 1/2" long. There is a pressed in 2" dia. double sealed bearing with the inside diameter honed to 1.002" (to slip over your prop shaft) its...
Top