Performance Boats Forum banner

sender

  1. Jet Boats
    Anyone know what length sender to order for a 20g bow tank in a 1974 tahiti, also can this be snaked in without removing the tank? looks like there is about 4-6 inches of room in there. I was able to get clip leads across it to prove it was the problem so i think i can get the screws out...
  2. Parts for Sale
    I have a tank for sale 24x16x12 works out to a little over 19 gal. 100.00 plus the ride from reno nv.
  3. Jet Boats
    Looking for some recommendations on fuel level senders that don't cost more than my carb:rolleyes: I have twin 13 gallon tanks and one gauge. Are there any quality "universal" senders on the market that won't break my back? Something in the $20-$40 range?
  4. Parts for Sale
    SHIPPED TO MESA AZ 2 WEEKS AGO FOR A GUY WITH A BIESEMEYER FROM HERE OR ANOTHER SITE OR CRAIGSLIST RETURNED FOR IN CORRECT ADRESS ANITIALS S M MESA AZ
  5. Jet Boats
    i got a gen 5 454 and i was going to put my sending unit in the back of the block right above my bell housing but the sender is 1/8" and the holes is 1/4" also the hole is so close to the side of the block and the sender is to big in diameter to get a straight thread even if the size of hole was...
  6. Jet Boats
    my boat came with a new set of gauges Stainless Steel Five Gauge Combination Set - Hardin Marine the guy i bought it from says that maybe the sender he included is the correct ones for oil and water temp, but he is not sure. reason i'm curious is because he kept the senders he had installed...
  7. GN7 On the Dyno
    I had a catastrophic oil leak today on my Chevy Vortec 350. I only noticed it because of the oil film when my bilge pump kicked on. I took a peek and the bildge had several quarts of oil in it. It was spraying out of the plastic end of the oil sensor / fuel pump switch. I easily could have...
  8. Outboards
    Ok take the retainer off, but how do you get that sucker out of the head? The temp sender.
  9. GN7 On the Dyno
    on a elc. temp sender is it ok to shorten the end that go's into the water/oil passage??? It's about 1/2" long would like to cut it down about 3/16 to 1/4". I'm useing it in a oil passage and trying not to block to much of it. gen 5 block, going in one of the oil cooler plugs by the pan. THANKS
  10. GN7 On the Dyno
    So after the endless debates on water vs oil temp ive decided the additional cost of a oil temp gauge is well worth the investment.. The consencus is to drill and weld a bung to the oil pan.. Well that aint gonna happen no time soon so i start looking for other locations. Above the oil filter...
Top