Performance Boats Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 6 Results
  1. GN7 On the Dyno
    Just need a baseline to start... 580-610 lift solid flat tappet crane gold 1.7 rockers. Don't want to pull engine to get numbers off the cam (if it even has any) checked them while repairing other custom parts (see below) intakes went from 10-21 exhaust more consistent at 21-23 I'm thinking 16...
  2. V-Drives
    I have a 1973 Sanger bubble deck circle flat with a BBC, 12* casale, and stellings 11-5/8x15 prop. I know that there are a lot of things that will determine the overall setting of the plates like the placement of the motor and vdrive. I was curious if anyone out there had just some starting...
  3. Jet Boats
    Could someone give me a base number to start with for holley jets size. I am running at 5100ft (vs San Diego) and it is so rich I get popping and very brown plugs. Also is there any need to change the timing at this altitude? Thanks
  4. Jet Boats
    I just picked up an MSD ready to run distributer, and it has several different advance springs and stops, does anyone have any suggestions as to what a good set up is- I believe it has the stiffest springs, so the slowest advance set up, it is going in a mild bbc with a comp cam 280AH-10 cam- I...
  5. V-Drives
    Hi All - last weekend I hooked up the driveline from the T400 tranny to the Casale V-drive case. I had 4 bolts with star washers on them. It was a little tricky hooking things up, since the driveline protector sleeve slid into itself, but didn't allow me sufficient clearance to put a torque...
1-5 of 6 Results