So, many of us drag guys use a clutch instead of shifting the whirl a way in and out of gear to leave.
We put a spacer between the rear drive dog and the bearing in the rear of the housing.
Anyone know the dimensions of that spacer off hand? I use the alcohol style whirl a way housing... so mine...
3-INCH thick MERCRUISER EXHAUST RISER SPACER
PN # 93320A3
1983-2002 CHEVY V6 V8 MANIFOLD
* Brand new
* no hardware
* only ran for 1 hour then pulled of because the risers were bad
* I put these on when I was installing thru hull exhaust and needed the exhaust to tilt...
Anybody know were i can find one of these, it's the nylon spacers that go between the base and top on a Victor tunnel ram. I know Dave at DNE used to sell them but last i checked with him years ago the CNC program was lost due to a drive crash and he hadn't recreated a program yet.
I have a super sucker aluminum 2inch carb spacer, I believe it's a holley sea demon, just wondering if this is ok on a airgap manifold? The spacer is the four hole design not an open style, the reason I'm asking is because on the cp performance site it says these carb spacers are good on both...
Selling a few parts...
Brodix HV2000 Intake Manifold - In near perfect condition - $300 - Sells new on Summit for almost $400
Edebrock 2" Spacer - In near perfect condition - $50
Stainless Steel Impellar - A Impellar detailed to an A-B - $500 - SOLD
Shipping is negotiable into the...