I have a drill fixture for a bravo one pattern with drill bits and hole saw- $125
1 1/2 inch bravo one drive spacer- end cut for use on a 3 inch imco shorty- $ 150
1 inch bravo one drive spacer - $150
2 marine KRC power steering racing pumps with pulleys - $225 each
I have Two H&R 3/4" hubcentric wheel spacers that I had for the back of my 2012 mustang gt, never used.
and two 1 3/4" BORA hubcentric wheel spacers for my 2014 silverado that I ran in the front to clear camburg UCA until I got new wheels.
$50 for each pair or $75 for all 4. Significantly...
Looking for advice, as the story of my life goes I am two inches short.... getting ready to set the engine in my day cruiser, when I mocked everything up the scoop was not where I wanted it, it was below the hatch, I want it just sticking thru the engine cover. I didn't want to raise the engine...
i have a verry special set of BBC SHOW CHROMED M/T VALVE COVERS WITH 2 SETS OF OFFENHAUSER BREATHERS TALL AND SHORT & 1" SPACERS, AS YOU CAN SEE THERE ARE NO HOLES PUNCHED OUT ON THIS SET. $250.00 FOR ALL
Wtb, b&m 250 blower idler & crank pulley spacers...if you got em' please help me out.
I could really use your help with this one. I am looking for some spacers for my b&m 250 blower.
The first spacer is the thin 3-hole crank spacer that sits between the 3v accessory pulley and...
Im selling my full set up ready to go, or selling in pieces.
-750 Carbs, Freshly built by C&J. $350.00 Each...... SOLD
-1 inch Wilson Tapered spacer. $90.00 Each
-Blue stainless blower Holley dual carb fuel lines. $40.00 Each....... SOLD
-Edelbrock Tunnel ram, polished and CLEAR COATED, $450.00
Was hopeing to keep my classic Mickey Thompsom valve covers...but with the expected delivery of my Jomar stud girdles and taller poly locks I knew I had to get some quality 1.50 spacers. @ $119.95 (:)eek(:)
Question...will the spacers be a PITA with trying to keep the oil leaks away or ahould I...