Performance Boats Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Bob Teague
    Hi just replaced seals and strut bushings. Shaft is back in and want the correct spacing between shafts. thx also i guess the spacing between the prop and strut. thx in advance!
  2. Jet Boats
    I have a couple questions about my headers on my daytona 19'. My headers are about 1/2" from one side of the hull. When I bought the boat i got the headers with it and the boat had a blown motor in it. Is there a difference between a blown set of headers vs. NA headers? I dont believe that i...
  3. GN7 On the Dyno
    any pics out there? Looks like I am going to end up w a huge bottom pulley, 8mm to get around 70 over with a psi. Guess my only option is a 6" spacer to put the pump outside of the belt?
  4. GN7 On the Dyno
    Im going to install a Edelbrock TR2X tunnel ram on my BBC maybe thursday and i need to build a new scoop tray. Im running a pair of 600 holleys inline. My boat is in storage and sort of a pain in the ass to drive there for a measurement that isnt going to help me. My brother has a shop that can...
  5. Jet Boats
    How much space should be allowed for pump flex within the shaft between the pump and the engine?
  6. GN7 On the Dyno
    Need to move my regulator to the front of the carb to allow better access to the valve cover. Anyone know off hand what the center to center bolt spacing is for the two front studs? Single carb, traditional mounting(not sideways like some tunnel rams allow...)
  7. PB Open Water
    Why doesn't this site double space between the end punctuation of one sentence, and the beginning of the next?
1-7 of 7 Results