Search Results for ‘start’

looking for a bbc top mount bellhousing for my sleekcraft sst going 4pt with rails and motor plates anybody making anymore

Not even October yet and got my Needles entry for next year. This year we're planning on bringing the "new to me" Canyon.... which I've hardly touched :rolleyes: Helps me finish projects if I have a dead line :thumb: Pics on the build forthcoming. I know it's early, any of ya'll have plans for...

"Skater Tanks - The Real Story" full screen photo slideshow on FullScreenPhotos.com ............. get a cold beer, or two. :thumb:

This has been getting worse for approx' one month; Starts just fine when cold....Then, after warming up fully, it starts having problems...Turns over just fine(Plenty of battery power) but it won't light......Takes a few times to get it to go finally...Until yesterday; It refused to...

Question for those that raced this past weekend; Honestly, Did this reduced distance change the boats a true 5 tenths or does it need to be more like 6-7 tenths ? Or did anyone see more of a performance loss than 7 tenths of a second? Thank you, Joe

I'm sure some of you have done this before so I figured I'd ask and see what your opinions are. I currently have a pump gas 489 I built about 4 years ago when my budget was really tight and just couldn't justify swinging the Aftermarket big bore block. However the desire for more performance...

I usally get time to run my boat at least once a month......but I've really been busy... so not so much this winter...

What's a good oil to use on a fresh start up,540 Chevy does have assembly lube on all the surfaces now ect bearings.And will prime the oil pump.Thanks JOHN SR

HOPE YOU ENJOY:))THumbsUp 19' PREDATOR / CHEYENE FROM THE NELSONS CAMP

Got a reasonably early start out to Big River last Friday, then had a blowout on the trailer about a mile past Chiriaco Summit. Strapped up the axle and limped into Blythe, got a new tire and finally into Parker at about midnight, only took about 8 hours. New tires and a spare before the next...

Much appreciate any ideas/assistance in advance... I just bought a 2006 Carrera jet boat with 496 MPI motor and a Dominator jet drive. The motor has about 90 hours on it and for the most part the motor runs great with great throttle response and smoothness that you would expect from a...

Hello, Have a casale v drive with in and out feature. Is it better to start engine in neutral and shift while engine is running or start engine while in v drive is in gear? Thanks for any help.

I would like to start learning the things I need to know about my jet boat. I know it has a Ford 460 engine. it is running a tunnel ram with 1 Holly 800 carb. I was told the lower end was stock, but that the cam was replaced with a wilder one when the fella rebuilt the engine, and that the...

I have a stock 1994 454 carb motor. it is almost impossible to start while on the water. once it is running, it runs good. if I shut it down it will start right up. if I let it sit for more than 15 minutes I have to hold the throttle wide open till it fires. it acts like its flooded. it's done...

I have a 22' schiada, I have two props, neither marked..... would a 12 x 15 work??? try'n to get a good starting point.. also its a LH prop...

Just picked up a new toy the other day!!! It's a 20' SleekCraft Tunnel. Has a 454/Dominator/Snoot/PD combo on it. I've never owned a jet before, so here we go! Just wondering if there is anyone in the SW Michigan area? Looking for others to go boating with, possibly drink a cold beverage or...