surge

TRYING TO STOP MY BLOWER SURGE , 392 HEMI :))THumbsUp:))THumbsUp:))THumbsUp,871 MOONEYHAM STRIPPED ON GAS 278/282 DUR. INTERCOOLER,ZOOMIES ,CROWER HAT INJ, VERTEX, PORTED HEADS BLA BLA BLA OK DONT TELL ME ITS A RICH/ LEAN THING I KNOW ,,,, HOW DO YOU STOP IT , THIS IS A NEW ENGINE I HAVE NEVER...

Got a newer truck with integral controller from factory so thought go the elec/hydro route but several trailer guys I've called to redo old trailer to discs and install system say today's surge the way to go... I'm definitely not made of money, but don't want to make a mistake for a delta of a...

Does anybody know who can build a bullet surge tank with a float bowl provision? Imco said they can't make one. Any help would be appreciated.

I'm getting a surge, almost a miss, between 3200 and 3800 rpm. The motor is a 508 BBF, 12:1, .715" lift mechanical roller, timing set at 34 total. Rings, bearings, timing set, valve job, lifers and rockers this season, but the bottom end is basically the same combo as last year. What's new is...

Guys, My EFI Blown 540 is getting closer and I need to figure out the fuel system for the Rayson Craft. I have saddle tanks and I'd like to be able to switch from one to the other while using the high pressure elec. fuel pump. I've been told elec. fuel pumps do not like to suck, so the idea is...

What causes the motor to "surge" like a blown motor when it's first started and then after it's is rev'd??? It surges between 900 and 1200 RPM's then smooths out and ends up at 1200 RPM .... until I rev it again ..... :notsure: :dunno:

wtb

SURGE

iam building a old school hydro and iam puting a 396 bbc in and a 6-71 blower. the motor is all stock but pistions. i want that blower surge with out alot of psi. and i need a cam . what lobe cam seperation i need 110 or 114 115? my rpm range is 1500 to 4500 thanks bonzibrian ps v-drive...