Performance Boats Forum banner
Cancel

Search Results for ‘wireing’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results

Search Tags

aluminum amp bbf berkeley big block blower blown boat boats bow bravo buy cam car carb casale cat chevy complete cover covers cruiser custom daytona deck diverter drag drive eliminator engine exhaust flat ford fuel gas gears good guys hallett havasu headers heads holley hondo hot hull hydro impeller info intake jet lake long marine motor msd njba oil open pan parker parts performance pics place plate project prop pump question questions race racing ram regatta river run runner sale sanger sbc scoop set ski stainless steering tank time today trade trailer tunnel turbo valve vdrive video wanted weekend wtb
  1. Audio
    I have (2) 2ohm dual voice coil 12" subs and I am trying to accomplish a 1 ohm load at the amp. Is this possible?
    subwoofer wireing
  2. GN7 On the Dyno
    Does someone make a wire connector large enough to put 2 10ga.wires in?? That would be nice
    alternator question quick wire wireing
  3. Jet Boats
    Im Using An Msd Distributor, But Im Not Running A Box. It Is The Msd Ready To Run With The External Blaster Coil. Should I Run The Resister With This Set Up, Or Just By Pass It All Together? Ive Been Told To Run It Both Ways. Just Currious Witch One Is The Best Way To Hook It Up.
    resist wireing
  4. Jet Boats
    I will be rewireing my boat this winter but I need to see how to run across from the engine to the deck and make it look clean and a safe run can you guys post some pics of how yours are run across Thanks Eric
    wireing
  5. Jet Boats
    What method's do You Guy's use to anchor or support You'r wire harness ,up under the gunnels? I am looking for a nice ,clean ,method to mechanically fasten My harness tight up under the gunnel. Something that is strong and wont fall down. Pic's,ideas or suggestions would be greatly...
    anchoring harness wireing
  6. Jet Boats
    I am try to understand the this wireing schematic but I dont see where the distrubreter (sp) is tied in to the system I have a HEI can someone show me where it ties in Thanks
    wireing
1-6 of 6 Results
Top