Performance Boats Forum banner
working
1-10 of 54 Results
  1. Other Stuff for Sale
    my little compressor wont go passed 50 pounds wont keep up with a air grinder or even a paint gun..........
  2. New member Introductions
    I made it, the password thing kept me at bay..... Oh well here I am, Hello to peeps i know and the ones I dont HELLO.... Miss all my boating peeps....
  3. Parts for Sale
    Custom made all billet foot control, powder coating available. P/Pal shipped $321 (raw aluminum), M/Order $310 shipped (raw aluminum). Let me know if you'd like one. Far superior to N-CONTROL units....3/4" sq billet linkage arm, 100% captive roller track system, 1/4" wide billet Delrin Rollers...
  4. West Coast - North
    I may be working in Boise for a few weeks and wanna know more about "boys night out at the lake" on Tuesdays. I know it would be asking a lot to see if a Utah boy would be welcome? :)Unsure
  5. Jet Boats
    I just installed my new motor and and msd 6m with the soft touch rev limiter. The tach is no longer working and from the wiring diagram it shows the grey wire is the tach. The boat originally had the gm hei, did i miss something somewhere any input would be great.
  6. V-Drives
    The deck has been fixed and now its in paint for detail wrk and some ghost flames on the deck useing a bright yellow at first changiny to pearl light purple fading into wood color
  7. Jet Boats
    Any idea what kinda working pressure a pd hyd pump makes and how much a pd size cylinder takes in volume to extend or maybe specs?
  8. PB Open Water
    Hi All - I have a 6000 RPM Hardin marine tach (# 105944604) that I recently installed on my '79 Gullwing. Previous tach worked fine and the boat turned about 5,400 RPM. The Hardin tach seems to work fine at low RPMs but only goes up to about 4,000 at full throttle. Any input you have is...
  9. V-Drives
    started working on the new stevens today.I knocked the engine over earlier in the week dented the exhaust elbows pretty bad it was where it necked down from 3" to 2.5" I have 3" tips so I cut the dented part off and noticed I could open up the exhaust about a 1/2 inch (see pics) do you think...
  10. PB Open Water
    Went to pull the cover off my boat today and hit the switch to lower the drive, went about 2/3 of the way down before starboard ram seems to be getting stuck. Put it up and down a couple times with the same issue. Checked fittings, fluid, no leaks everything seems to be as it should be. Any...
1-10 of 54 Results
Top