Performance Boats Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1 (Edited)
For Sale,
My father built this boat over a coarse of 5 years, every nut and bolt was remove and replaced. The motor is a high nickel bow tie Chevy race block. The motor was built by Tim Morgan in Walnut Creek CA. The heads were done by Brad Anderson. The Carbs were done by the carb shop. Paint job by Art Himsil. No cost was spared on this project. No rubber hoses all stainless hard line or braided line. Haylon fire system, Boat is very reliable and gets lots of attention. The bottom of the boat was blue printed. A lenco clutch an drive line was installed as well. The fuel system was custom made with 2 fuel pumps and over sized fuel tanks 16 gallon each and can be removed as one unit. Hate to sell it, Over 50,000 dollars have been put into this boat, but it is not being used enough. Boat is located in Napa CA. More pics and be sent with request. Can separate the motor for the right price.

Asking 26,500 OBO
707-208-0121
[email protected]
 

Attachments

1 - 1 of 1 Posts
Top