Performance Boats Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 · (Edited)
1974 Sanger five rib drag hydro medium layup casle box with 1.37 gears , aquamet 1 1/8 prop shaft, Lenco bellhouseing , clutch and drive line, 2lb co2 bottle for clutch, rpm data logger ex temp , blower , fuel and oil psi, engine and drive line rpm monitored, custom work cover and full canvas cover.
435 bbc littlefield 8-71 blower freshly stripped ,littlefield tented floor intake,Enderle bugcatcher with hat switch to engage clutch and Enderle 80-a pump. eagle steel crank with new tri-armor clevite bearings ,Howard’s aluminum rods , dart heads manly ss severe duty valves fresh new kmotion a- 1000 springs , new arp rocker studs and adjusting nuts ,new Howard’s 1.7 rockers. Crane stud girdle. New custom ground crane cam 768 in 745 ex 299/310 advertised duration 4-7 swap , new crower severe duty lifters with pin oilers , aries pistons with new total seal rings , new Moroso race oil pump, new arp head and main studs, new mezrie starter, msd 20 amp promag. All Pulleys and pills for tuning, Engine has approximately 1 min run time to set timing
Boat easily runs pro eliminater class

1998 hallmark enclosed trailer two fold down beds , Cabnets fridge, toolbox 2 a/c’s , electric jack , winch inside , fuel jug holder , 16’x 30’ flat roof canapy
Also have extra gears, prop shaft, prop, 6-71 blower needs restriped ,blower intake ,Enderle bugcatcher, Enderle 80-a pump, large lifeline shute jacket recently certed .
Complete ready to race package
40,000 or serious offer
(361) 249-5105 John
Located in south Texas






Sent from my iPhone using Tapatalk
 
1 - 2 of 2 Posts
Top