Performance Boats Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
I have a extra pump bowl and nozzel it has a aluminum ( I belive) impeller
it is going to need to be gone through the front bearing is rusty so it doesn't spin so good, but there are no major nicks in the impeller just some minor ones has been sitting for a while came with a project boat.
bowl is I belive a JC? and it has a nozzel with reverse and a skeg that is on a hinge that is down and as speed increases goes up to help with steering I guess my other pump doesn't have that setup.

Make Offer may seperate...













 

·
Registered
Joined
·
37 Posts
Discussion Starter #3
LOL I know i have only seen a couple like this and they were alot smaller... what is somthing like this worth... i am thinking about ebay...
 

·
Registered
Joined
·
785 Posts
how much ?

does anyone make a sandwich adapter to mount it to a Jacuzzi intake ?
 

·
Registered
Joined
·
358 Posts
suction 100-150 bowl about the same shaft and impeller 150 maybe 400 for the whole thing unless it an aqua net shaft which looks like pretty much a stock set up
 

·
Registered
Joined
·
37 Posts
Discussion Starter #8
I would be happy with $200 just sitting around but if it doesn't sell I am going to go through it and rebuild it with a stainless impeller and install it in my boat, with my JG bowl and a drop
 
1 - 8 of 8 Posts
Top