Performance Boats Forum banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
1,493 Posts
Discussion Starter #1 (Edited)
Lots of port work, 2.30 intake valve, they were ported in to pushrod area, had aluminum epoxied in, i had new aluminum pieces made and welded in, they will need epoxied on the back side, but they will not come out, one came out on me thats why i had them welded, I have rocker studs, BLP gurdles and locks, roller springs (huge lift). $550 for the pair less extra parts obo, plus shipping from OK. they are not cracked, assemble and add a little epoxy and they are ready to go,
the guy i got them from had them on a big cubic inch motor, i also had them flowed before I ran them, and have the sheet.
IMG_0008.jpg IMG_0009.JPG IMG_0010.jpg IMG_0011.JPG
 

·
WET MEMBER
Joined
·
1,251 Posts
let me know if the sale does not go through
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top