Performance Boats Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
burley

Who is going????????????????
gn50
All I can say is engine is apart and pistons are on order. Because I'm sure everyone wants to know what happened this time. Not enough valve to piston clearance on exhaust and pistons were hitting the heads. No I didnt build this one. It was professionally built and I'm pretty pissed. I still haven't given up on Burley and I'm glad it failed at the river over the holiday weekend rather than at Burley.
 

·
Registered
Joined
·
5,312 Posts
Hey Chris, inquiring minds need to know who built that engine???????

This would be a perfect time to throw him under the bus:stir::yes: Piston to valve clearance should be a pretty easy thing to check while you're putting the engine together...

Just busting you nuts a little. Hope to see ya at Long Beach...

Steve
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top