Performance Boats Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
V-Drive 4 ever
Joined
·
1,810 Posts
Discussion Starter #1 (Edited)
The link below is the exact intake i have and is a Show Polish job. Edelbrock 71611 intake New 600 bucks Never used sell for 300.00 which is less then the Non Polished one.. changing build directions is all ..
https://www.summitracing.com/…/edl-…/overview/make/chevrolet
530-333-1047 ..

I also have a set of Oval Port heads that have a lot of Port work done and valves opened up too 2.19 and 1.88 . Fresh rebuild on them cost me over 400 bucks not including the springs and retainers and locks. . New springs for solid roller cam .700 lift and new retainers and keepers. have about 900.00 into the heads. sell for 700.00 these are a great oval port head when works been done to them which mine has had lots of work done.. . 110cc Open Chamber.. ..
Heads are still in the Bag from having them built for my combo i WAS doing. went Bigger so selling off all the parts i have from the build..

Bill 530-333-1047 home
530-903-1623 Cell
 

Attachments

·
V-Drive 4 ever
Joined
·
1,810 Posts
Discussion Starter #2
Bump. still have this. Mint condition. never used or bolted down.. Show quality..
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top